Hello, I have decided to start modding my RX-8, I come from a RX-7 back ground have a few part laying around, which is ACT clutch/flywheel combo.

From my understanding I can use the ACT flywheel, though question is can I use the clutch too, I figure I will have to at least use a different friction disk, but the pressure plate is a "push" type Turbo RX-7 type. I would be nice to be able to use this setup, because its all brand new and never used.


Thanks.

 

if it is a FD turbo flywheel and clutch then it should fit.

 

FD and FC turbo flywheels are pretty much the same. The pressure plates are different though do to the different type of slaves.

 

should work then

 

Maybe the real question I should be asking, is RX-8 clutch, a Pull type, or push type?

 

push type.