Notices
Series I Aftermarket Performance Modifications Discussion of power adding modifications

which intake is best?

Thread Tools
 
Rate Thread
 
Old May 15, 2009 | 09:33 PM
  #1  
Tragedy47's Avatar
Thread Starter
Registered User
 
Joined: Apr 2009
Posts: 13
Likes: 0
From: CA
which intake is best?

i'm thinking about getting an intake. i live in california so i was thinking k&n CIA or racing beat air box setup or an AEM CAI which is best for our car? whats going to get the most gains? and i've only put short ram intakes and my other cars and it got more hp but my mpg went down do CAI's lose mpg? or stay even or gain?
Reply
Old May 15, 2009 | 09:37 PM
  #2  
BrightEyes's Avatar
Styrofoam Boots
 
Joined: May 2009
Posts: 45
Likes: 0
From: Brampton Ont.
In my opinion, the stock air box on the rx8 was engineered quite well, it doesnt need to be replaced by a $250+ CAI.
most if not all of those intakes wont get you more than 6-7 hp, and the stock box looks good overall in the engine bay too.
go here https://www.rx8club.com/showthread.p...e+stock+airbox
and follow the instructions, its all you need, and it saves you some green hahahaa.

Last edited by BrightEyes; May 15, 2009 at 09:41 PM.
Reply
Old May 15, 2009 | 09:55 PM
  #3  
Tragedy47's Avatar
Thread Starter
Registered User
 
Joined: Apr 2009
Posts: 13
Likes: 0
From: CA
thanks alot
Reply
Old May 15, 2009 | 10:10 PM
  #4  
myriadshalaks's Avatar
rot8ing
iTrader: (1)
 
Joined: Feb 2007
Posts: 1,538
Likes: 1
From: merritt island, fl
just remove the intake, vfad and maf, then put a screen over the hole in the throttle body and cap the secondary vacuum inlet. You'll get a cel, but it's just the maf. It'll idle like ****. But it'll sound awesome. And you'll get the most gains. they'll be sporadic. but hey, it's all about peak horsepower, right? c'mon. use the search button.
Reply
Old May 15, 2009 | 10:19 PM
  #5  
cjkim's Avatar
^noob
 
Joined: Jan 2006
Posts: 1,340
Likes: 1
From: socal
Originally Posted by myriadshalaks
just remove the intake, vfad and maf, then put a screen over the hole in the throttle body and cap the secondary vacuum inlet. You'll get a cel, but it's just the maf. It'll idle like ****. But it'll sound awesome. And you'll get the most gains. they'll be sporadic. but hey, it's all about peak horsepower, right? c'mon. use the search button.
screens are for noobs
just run the accordion tube straight from the throttle body.
Reply
Old May 15, 2009 | 10:21 PM
  #6  
myriadshalaks's Avatar
rot8ing
iTrader: (1)
 
Joined: Feb 2007
Posts: 1,538
Likes: 1
From: merritt island, fl
good idea. stretch it out and make it a CAI.
Reply
Old May 15, 2009 | 10:43 PM
  #7  
NACer4lyf's Avatar
oh yeah!
iTrader: (1)
 
Joined: Feb 2009
Posts: 480
Likes: 0
From: Upstate SC
Originally Posted by myriadshalaks
just remove the intake, vfad and maf, then put a screen over the hole in the throttle body and cap the secondary vacuum inlet. You'll get a cel, but it's just the maf. It'll idle like ****. But it'll sound awesome. And you'll get the most gains. they'll be sporadic. but hey, it's all about peak horsepower, right? c'mon. use the search button.
DUDE why didnt i think of that haha i just scrapped my AEM in favor for this..

GENIUS bro genius!!!
Reply
Old May 15, 2009 | 11:25 PM
  #8  
nycgps's Avatar
Out of NYC
iTrader: (1)
 
Joined: Jun 2005
Posts: 19,881
Likes: 36
From: Planet Earth
Originally Posted by cjkim
screens are for noobs
just run the accordion tube straight from the throttle body.
the 2 air straighter are there for a reason.
Reply
Old May 15, 2009 | 11:37 PM
  #9  
cjkim's Avatar
^noob
 
Joined: Jan 2006
Posts: 1,340
Likes: 1
From: socal
Originally Posted by nycgps
the 2 air straighter are there for a reason.
i don't think you're following the thread

or i suck at online sarcasm
Reply
Old May 15, 2009 | 11:39 PM
  #10  
myriadshalaks's Avatar
rot8ing
iTrader: (1)
 
Joined: Feb 2007
Posts: 1,538
Likes: 1
From: merritt island, fl
Reply
Old May 15, 2009 | 11:57 PM
  #11  
05rex8's Avatar
sold the 8... :(
iTrader: (7)
 
Joined: Feb 2008
Posts: 4,917
Likes: 0
I have this intake. It's the best.

Reply
Old May 16, 2009 | 01:12 AM
  #12  
getdamafiaonyou's Avatar
Registered User
 
Joined: Sep 2008
Posts: 348
Likes: 0


triple short ram ftw.


or you could always go with dual cold air

Reply
Old May 16, 2009 | 02:23 AM
  #13  
cjkim's Avatar
^noob
 
Joined: Jan 2006
Posts: 1,340
Likes: 1
From: socal
lmao, i'm seriously trying to figure out that triple one
Reply
Old May 16, 2009 | 02:53 AM
  #14  
8rocks's Avatar
Registered User
 
Joined: May 2008
Posts: 162
Likes: 0
Originally Posted by cjkim
lmao, i'm seriously trying to figure out that triple one

That's a CAS (cold air storage) for those really hot days; the reserve Cold air held in the CAS comes in handy then for that much needed boost.
Reply
Old May 16, 2009 | 03:07 AM
  #15  
rx8phase1's Avatar
Registered User
iTrader: (1)
 
Joined: Sep 2007
Posts: 410
Likes: 0
From: Chino CA.
just stick w the stock intake and put in a k&n drop in filter, if u put other intakes u will loose the lilttle torque u have and u barley gain any hp it's a waste of money all they really do is make ur car sound a lil louder thats it!
Reply
Old May 16, 2009 | 03:44 AM
  #16  
Spinning Sushi's Avatar
I <3 Sushi
iTrader: (21)
 
Joined: Aug 2006
Posts: 3,967
Likes: 4
From: SoCal
Originally Posted by BrightEyes
In my opinion, the stock air box on the rx8 was engineered quite well, it doesnt need to be replaced by a $250+ CAI.
most if not all of those intakes wont get you more than 6-7 hp, and the stock box looks good overall in the engine bay too.
go here https://www.rx8club.com/showthread.p...e+stock+airbox
and follow the instructions, its all you need, and it saves you some green hahahaa.
Someone actually referenced my intake mod. I feel special.
Reply
Old May 16, 2009 | 03:51 AM
  #17  
cjkim's Avatar
^noob
 
Joined: Jan 2006
Posts: 1,340
Likes: 1
From: socal
Originally Posted by Renesis SE3P
Someone actually referenced my intake mod. I feel special.
last i checked, your 8 wasn't using the stock intake either (before it died)..
Reply
Old May 16, 2009 | 11:21 AM
  #18  
BrightEyes's Avatar
Styrofoam Boots
 
Joined: May 2009
Posts: 45
Likes: 0
From: Brampton Ont.
Originally Posted by Renesis SE3P
Someone actually referenced my intake mod. I feel special.
lol yea, its an awesome thread. thanks for putting it up btw
Reply
Old May 16, 2009 | 12:37 PM
  #19  
lepichichi's Avatar
I LuV mY Rotary....
iTrader: (10)
 
Joined: May 2007
Posts: 3,408
Likes: 0
From: killADelPhia
Racing beat!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
fourwhls
RX-8's For Sale/Wanted
7
Feb 20, 2019 05:16 PM
Sato Tatsuya
Canada For Sale/Wanted
3
Oct 5, 2015 03:09 PM
Zube6115
Series I Trouble Shooting
8
Sep 30, 2015 12:57 PM
XianUnix
Series I Trouble Shooting
6
Sep 29, 2015 03:48 PM
Jb4ker96
Series I Trouble Shooting
0
Sep 27, 2015 10:06 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 08:54 AM.