Vasichko

iTrader: (1)

I was looking at getting this exhaust. Isnt it 3"?

scsi

looks 3" to me

Vasichko

iTrader: (1)

Hmm, Ive been thinking about getting this one. Im planning to do a turbo setup but dont know if it would be too loud of if Id lose alot of torque.

YayAreaBruh21

yes its 3" and the torque issue has already been covered. S-E-A-R-C-H

NgoRX8

iTrader: (1)

honestly, i think the only thing you'd notice would be the sound is louder, which in turn, is making you think you're slower. lol

XDEEDUBBX

yea there is no "noticeable" torque difference...

scsi

can a resonator be put on the connecting pipe?

ddub

Yes, but it's really not that necessary. I recently put my HKS single on with a high flow cat as well. Yes it's loud, but it's not a bad loud and it doesn't bother me. It's a good deep sound and at low throttle and normal cruising it's incredibly tolerable. It gets pretty loud at redline, though, but it's not horrible.

NgoRX8

iTrader: (1)

scsi already has the rp supercat, so i assume that's why he wants a resonator installed.

ddub

Well then my post is still relevant, it's not that bad

I had the rx8store dual can catback before with a resonated/catless midpipe. It was actually louder in the lower/cruising rpm's than the HKS single + supercat. In the high rpm's its about the same, but the HKS is deeper and sounds better in my opinion.

scsi

what i meant by will it fit is on the car is there enough space where the connecting pipe is to also accommodate a resonator or small muffler?

do you plan to take some vids or sound clips? ive seen a few on youtube and it seemed too loud for me.

ddub

I believe there is space, but it'd have to be a fairly skinny/short resonator.

Yah I'm going to make a video eventually, just need to get access to a camera with video capabilities.

mysql101

if you want to know if there's space to mount it .. check the first pic in this thread.

ddub

Pretty sure he's talking about once it's mounted ON the car, is there space between it and the bottom of the car and around the pipe to put in a resonator or small muffler. It all changes once the pipe is actually bolted on the car, it's tight in some places but I think it can be done if the resonator is short/skinny.

mysql101

ah. makes sense.

i already have a resonator on my midpipe, doesn't seem to be helping me much.

scsi

exactly what im wondering. perhaps a small muffler might work too, like one that teamrx8 used on his custom exhaust

notice the 2 in line mufflers here

ddub

Something around that size should fit fine.

xbeatxdownx

xbeatxdownx

And now the video...I need a new starter

http://www.youtube.com/watch?v=htaO9ZL33Eg

NgoRX8

iTrader: (1)

sounds awesome! congrats!

ViR2

sweet exhaust