AP midpipe taper off?
Guest
Posts: n/a
AP midpipe taper off?
So im getting a custom catback done and am going full 3" from the header to the muffler, then inside the muffler splits to 2 2.5" for tips in stock location. The muffler being used is a cherry bomb vortex. Since it is not a chambered muffler, i am looking at either the shop fabbing a 3" midpipe with two resonators and using an allflow non catalytic converter ( http://www.siliconeintakes.com/produ...roducts_id=320 ) to pass the visual state inspection required in pa or buying a midpipe and adding the allflow? just looking for some input... But the question is, by looking at pics of the AP midpipe, it looks like it tapers off to a smaller diameter between the second resonator and rear flange. Is this correct? Is there anyone that would be able to mearsure this for me? Thanks!
4FragileHearts&WeakLimbs
Joined: Aug 2009
Posts: 105
Likes: 0
From: El Centro C.A.
Yes it does taper down both in the beginning and the end IMO to fit the stock header and rear section. I recently installed one, my setup was a custom 3" to stock muffler and let me tell you it sounded like ****! Do install some kind of resonator. Anyway what I did with my AP midpipe was cut the ends off and weld a 3" flange up front where it meets with the header and weld the rear section to my custom tubing.
Thread
Thread Starter
Forum
Replies
Last Post
JimmyBlack
Series I Major Horsepower Upgrades
273
Feb 10, 2020 10:23 PM
qtipconnoisseur
RX-8 Parts For Sale/Wanted
9
Oct 29, 2015 07:19 PM
br0wm
Canada For Sale/Wanted
5
Oct 24, 2015 11:06 PM
yapakanichi
Series I Aftermarket Performance Modifications
4
Sep 25, 2015 07:55 PM
