oh, very nice, you lucky son of a b!! j/k

 

Noise of the belts...my car souds the same as it did before I installed the pulleys. Are you sure nothing is wrong with your ride?

 

Ha. Dan over at Vivid takes care of us..

 

i can see that, howd you get on there?

 

Just talked with him a few times & spent lots of money.

 

oh, i thought you were sponsored or something

 

They are a sponser...

 

just bought a used pulley w/o screws.........anyone know where i can get the screws for it

 

I'm not sure, since I dont even remember what the screws look like that I used to install mind.. ITs a long shot, but you could shoot AP an email?

 

i got the screws.........if anyone else wants to know there at orielly auto...auto zone, advance pep boys, and napa didnt have em.......now i just gotta find smaller belts

 

wouldnt you just use the screws that came off the stock pulleys?

 

no theyre too big you have to have ones with a smaller head(socket head)

 

o ok didnt know that

 

No I reset the E-shaft profile and pulled the Room fuse. Then I pulled the car onto the highway on-ramp and stood on the gas and the top of 2nd gear I got a flashing CEL, backed off and pulled over on the shoulder and pulled the code, Misfire rotor 2. Cleared the code and it never came back

You have to do the 21 brake tap reset in order not to get a CEL since the pulley is smaller than the stock crank pulley, and will throw off the e-shaft profile.

 

i installed the ap pulley today..........took on a test drive everything works great........but i cant tell if i got any power feels pretty much the same.....too bad........looks cool though...