Originally Posted by wcs
(Post 3111579)
AP?
LOL hasn't done anything for me. free post |
sarcasm ... not always understood.
|
^sarcasm is hard to express over the internet! haha
|
Originally Posted by Razz1
(Post 3106073)
I have seen 10 hp on 100% stock motor.
15 to 20 on modified. These are Dynos. Main thing is other benefits. Runs leaner at idle so you don't foul plugs and flood engine. fans come on sooner. More oil is injected to seals etc........... I've seen the best improvements made on 8's without a cat.
Originally Posted by jmc23200
(Post 3106018)
If anyone has a Non FI RX8 with CobbAP and a final tune from MM, could you share your AFR for comparison?
Just gimme a couple minutes to scan them and get'm uploaded.
Originally Posted by myriadshalaks
(Post 3114189)
sarcasm ... not always understood.
Originally Posted by 04RX8man
(Post 3117302)
^sarcasm is hard to express over the internet! haha
Some people drunk dial, I free post. We all have our crosses to bare. To be honest I would NOT recommend to anyone that they buy the AP if the only thing they were going to do with it was use the Cobb Stage 1 tune. That tune really isn't that good IMHO. My car actually throws a Lean Condition cell when I use the Cobb Stage 1 tune. I can't remember the P# right now, I will try and find it. Anyways the Cobb is some much more than that, its a tool and a good one at that. I bought it because I wanted to monitor all the things that it can, and eventually make my own tunes using the Access Tuner Race software. (myriadshalaks I haven't forgotten about trying your free tunz. I'm on holidaze this week, I hope to get around to trying them out) I also knew that I would be getting MM to tune my car, more specifically I knew I would be getting him to tune it for my nitrous setup. With that being said, you will notice my AFR's are on the rich side in the dyno's. |
3 Attachment(s)
First Dyno (ever)
Bone stock, car was only 4 months or so old. Date Summer 2005 Attachment 277445 Second Dyno. Drove to Chicago for this one. Zex 55 shot, Cobb AP, RB CAI and Ram Air, Under drive pulleys, lightened flywheel, MM's first tune on my car. Date = Summer 2008 (however the dyno says 2007, it couldn't have been that long ago) Attachment 277446 Third Dyno. Back to the same place as my first one. Mods = Added a High Flow cat, and up'd the nitrous to a 65 shot. MM's second tune on my car Date = Fall 2008 Attachment 277447 |
Congrats! That is a kick ass dyno. Nice and smooth lines! :)
|
Originally Posted by DarthRX8
(Post 3135439)
Congrats! That is a kick ass dyno. Nice and smooth lines! :)
Clean plugs, new wires and coils helps as well. The cell that the Cobb Stage 1 tune causes is (mention in post #29) P2270 Rear HO2S signal stuck lean ON 2 HO2S ´ (See DTC P2270 ) I was thinking about posting something about this in the Cobb forums however with all the modifications that I have I don't think it would go well, but meh I will do it anyway. http://forums.cobbtuning.com/forums/...362#post614362 |
All times are GMT -5. The time now is 12:49 PM. |
© 2024 MH Sub I, LLC dba Internet Brands