Upgrade your swaybar bushings
#1
Upgrade your swaybar bushings
It took a few months and a very slow boat from down under, but now we can upgrade to poly swaybar bushings and use our stock hardware:
http://www.dpeweb.com/ProductDetails...9&vehicleID=58
p.s. these should fit the stock and MazdaSpeed bar.
http://www.dpeweb.com/ProductDetails...9&vehicleID=58
p.s. these should fit the stock and MazdaSpeed bar.
#6
No respecter of malarkey
iTrader: (25)
http://www.jegs.com/webapp/wcs/store...0059&langId=-1
universal 1-1/16" Part no. 355-9-5162G for black color bushings, replace the "G" with "R" for red, $13.95 for a pair from Jegs linked above
When you go to install them the bracket on the top side will slightly overlay onto a clip that holds the ABS wire, bracket holes are slotted - push them downward as far as you can, when you tighten the nuts down the bracket will pull down and conform properly with a slight overlay on the clip, nothing to be concerned with
universal 1-1/16" Part no. 355-9-5162G for black color bushings, replace the "G" with "R" for red, $13.95 for a pair from Jegs linked above
When you go to install them the bracket on the top side will slightly overlay onto a clip that holds the ABS wire, bracket holes are slotted - push them downward as far as you can, when you tighten the nuts down the bracket will pull down and conform properly with a slight overlay on the clip, nothing to be concerned with
Last edited by TeamRX8; 03-03-2006 at 03:47 PM.
Thread
Thread Starter
Forum
Replies
Last Post