Parting Out my RX-8
04-28-2010, 12:23 PM
#176
Registered
Join Date: Aug 2009
Location: Los angeles CA
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Category: Accessories
Price: $1400
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): Series II
Item Condition: Used
04-28-2010, 04:37 PM
#177
Registered User
Join Date: Apr 2010
Location: caliornia
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
I am also interested in trades for LS1 and T-56 transmission, center console boat or gsxr
I've got some bad news. I tried to show off in front of my friends in a parking lot and found out the hard way how strong wal-mart light post really are. However, this is good news for all you other RX-8 owners out there. I am parting out my RED '04 Show-Winning RX-8 now. The car is in Charleston, SC. Here is a list of some of the MAJOR parts I am selling:
1.3L 45,000 Miles Engine (Compression Good): $1,400
6 Speed Manual Transmission: $850
AC Compressor: $250
Airinx Intake Kit: $90
Alternator: $75
Brake Calipers: Front $125 Rear: $75
Carbon Fiber Wing Seibon SOLD
Console Section Rear: $55
Dash Display Unit: $70
Door Driver Side Front: $300
Door Driver Side Rear: $200
Door Passenger Side Front (Minor Damage): $300
Door Passenger Side Rear: $200
Door Panel Driver Side Front: $150
Door Panel Driver Side Rear: $125
Door Panel Passenger Side Front: $150
Door Panel Passenger Side Rear: $125
E Brake Handle: $20
ECU: $125
Fender (Driver Side Front) $90
HVAC Controller: SOLD
Head Light Housing Driver Side: $250
Head Liner: $150
Hubs Front: $80 each
Pillar Covers: $35 a set (CAN BE WRAPPED IN CARBON)
Power Window Regulator with Switch: $70
Rear View Mirror: $55
Tail Light Driver Side: $125
Trunk: $100 (HOLES DRILLED FOR WING)
Seat Driver Side Front Leather: $500
Seat Driver Side Rear Leather: $200
Seat Passenger Side Front Leather: $400
Seat Passenger Side Rear Leather: $200
Whole black and Red Leather interior: $1500
Side View Mirrors: $105 each
Steering Wheel: $55 (airbag deployed)
Subframe Rear: $200
Veilside Side Skirt Driver Side: $60
Greddy Exhaust: SOLD
Greddy Turbo Kit SOLD
Profec E-01: $350
Axis Hiro wheels with Hancook Ventas Sport K104 245x35ZR19 -SOLD
ACT Clutch Kit HDG6 Mazda RX-8 RX8 04-08 05 Heavy Duty (10,000 miles on it): $75
I have every other part for the RX-8... Just too many to list. Send me a message if you need a part that isn't listed.
SOLD ITEMS:
HVAC Controller
Rear Tire Kit
Rear trunk carpet
CHECK HERE FOR PICTURES BEFORE ASKING-> Additional pictures at http://www.chrisosborne.name/rx8 <-CHECK HERE FOR PICTURES BEFORE ASKING
I've got some bad news. I tried to show off in front of my friends in a parking lot and found out the hard way how strong wal-mart light post really are. However, this is good news for all you other RX-8 owners out there. I am parting out my RED '04 Show-Winning RX-8 now. The car is in Charleston, SC. Here is a list of some of the MAJOR parts I am selling:
1.3L 45,000 Miles Engine (Compression Good): $1,400
6 Speed Manual Transmission: $850
AC Compressor: $250
Airinx Intake Kit: $90
Alternator: $75
Brake Calipers: Front $125 Rear: $75
Carbon Fiber Wing Seibon SOLD
Console Section Rear: $55
Dash Display Unit: $70
Door Driver Side Front: $300
Door Driver Side Rear: $200
Door Passenger Side Front (Minor Damage): $300
Door Passenger Side Rear: $200
Door Panel Driver Side Front: $150
Door Panel Driver Side Rear: $125
Door Panel Passenger Side Front: $150
Door Panel Passenger Side Rear: $125
E Brake Handle: $20
ECU: $125
Fender (Driver Side Front) $90
HVAC Controller: SOLD
Head Light Housing Driver Side: $250
Head Liner: $150
Hubs Front: $80 each
Pillar Covers: $35 a set (CAN BE WRAPPED IN CARBON)
Power Window Regulator with Switch: $70
Rear View Mirror: $55
Tail Light Driver Side: $125
Trunk: $100 (HOLES DRILLED FOR WING)
Seat Driver Side Front Leather: $500
Seat Driver Side Rear Leather: $200
Seat Passenger Side Front Leather: $400
Seat Passenger Side Rear Leather: $200
Whole black and Red Leather interior: $1500
Side View Mirrors: $105 each
Steering Wheel: $55 (airbag deployed)
Subframe Rear: $200
Veilside Side Skirt Driver Side: $60
Greddy Exhaust: SOLD
Greddy Turbo Kit SOLD
Profec E-01: $350
Axis Hiro wheels with Hancook Ventas Sport K104 245x35ZR19 -SOLD
ACT Clutch Kit HDG6 Mazda RX-8 RX8 04-08 05 Heavy Duty (10,000 miles on it): $75
I have every other part for the RX-8... Just too many to list. Send me a message if you need a part that isn't listed.
SOLD ITEMS:
HVAC Controller
Rear Tire Kit
Rear trunk carpet
CHECK HERE FOR PICTURES BEFORE ASKING-> Additional pictures at http://www.chrisosborne.name/rx8 <-CHECK HERE FOR PICTURES BEFORE ASKING
04-30-2010, 08:58 AM
#179
Registered User
Thread Starter
iTrader: (1)
Join Date: Feb 2008
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
should be about 85 to commercial, 115 to residence
75 to commercial 105 to residence
yes, the clutch will fit. I have the pump but it's a pain in the *** to pull out and unfortunately I don't have time.
yes to bose no to exhaust.
yes to bose no to exhaust.
04-30-2010, 10:08 AM
#182
My 8 looks like a Smurf
iTrader: (4)
Join Date: Sep 2007
Location: Ottawa, ON, Canada
Posts: 1,742
Likes: 0
Received 0 Likes
on
0 Posts
- remove driver side back seat bottom (just pulls out)
- unscrew metal plate, be careful with the connector underneath
- unclip connector
- unclip fuel line (be careful, fuel will spew out)
- remove retaining clip -- this is the tricky part. either go slowly with a hammer & flathead or borrow the tool from your dealer (it wasn't a problem when I asked)
- pull out pump slowly, let the fuel drain
- remove inside electrical connector and the small fuel line and you are done!
Just don't do like I did and forget to unclip the line before removing the retaining clip... cost me a fuel pump assembly
live & learn I guess!
05-12-2010, 09:29 AM
#186
Registered User
Thread Starter
iTrader: (1)
Join Date: Feb 2008
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
What's your location? How much for the center dash shipped to 18015. Can you send a couple pics to deejay.drez@gmail.com? Thanks
85
That pump comes out really easily... 15mins max. 2 lines and 2 electrical connectors.
- remove driver side back seat bottom (just pulls out)
- unscrew metal plate, be careful with the connector underneath
- unclip connector
- unclip fuel line (be careful, fuel will spew out)
- remove retaining clip -- this is the tricky part. either go slowly with a hammer & flathead or borrow the tool from your dealer (it wasn't a problem when I asked)
- pull out pump slowly, let the fuel drain
- remove inside electrical connector and the small fuel line and you are done!
Just don't do like I did and forget to unclip the line before removing the retaining clip... cost me a fuel pump assembly live & learn I guess!
- remove driver side back seat bottom (just pulls out)
- unscrew metal plate, be careful with the connector underneath
- unclip connector
- unclip fuel line (be careful, fuel will spew out)
- remove retaining clip -- this is the tricky part. either go slowly with a hammer & flathead or borrow the tool from your dealer (it wasn't a problem when I asked)
- pull out pump slowly, let the fuel drain
- remove inside electrical connector and the small fuel line and you are done!
Just don't do like I did and forget to unclip the line before removing the retaining clip... cost me a fuel pump assembly
live & learn I guess!Not sure what you're talking about.
05-19-2010, 10:56 PM
#188
Spin Triangles! Spin!
Join Date: Mar 2005
Location: Texas, US
Posts: 827
Likes: 0
Received 0 Likes
on
0 Posts
Last edited by dmorales; 09-09-2011 at 03:58 AM.
05-31-2010, 09:56 PM
#193
Special Agent Member
Join Date: Nov 2003
Location: Pine Bluff, AR
Posts: 198
Likes: 0
Received 0 Likes
on
0 Posts
Hello there, Looking to obtain a Vehicle Side Marker Electical Connector (Picture / Link to WTB Post) shipped to 71602.
Thanks!
Thanks!
06-05-2010, 02:28 PM
#197
Tetsumakysenpukyaku
iTrader: (5)
Join Date: Jan 2008
Location: Throwing Sonic Booms
Posts: 249
Likes: 0
Received 0 Likes
on
0 Posts
I'll take the ash tray as long as the spring and pins are still good, and I'll take the front arm rest pad if the button is still in tact. Prices shipped to 89031?
06-15-2010, 06:23 AM
#199
Registered User
iTrader: (1)
Join Date: Apr 2008
Location: PA-Atown
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
hey if you still have it im interested in the airnix intake...does that come mainly for the turbo kit? i had the greddy bolt on and it came with it, i had to sell the kit tho...and do you still have the plastic body piece which is located underneath the car which protects the engine of other important parts from being damaged, it connects to the bottom of the bumper and goes about midway back...in need of that, thank you very much
