Here are some sneak peeks of AZLizards 2005 MT Greddy Turbo install by BHR. This install is not complete but here are some of the fitting steps.
The Blue is the finished kit color though. I hope you all like as much as AZLizard does. SAMCO couplers (Gloss Black) and T-Clamps yet to be put on. A pinch here and a pinch there.





Blue inlet tube w/BOV will be done tomorrow.


AEM and all Turbo pipes in blue.

 

Good **** bro.

 

looking good!

people should refer to these photos when asking about how the aem intake fits with a greddy kit. I had the same tilt to my intercooler to allow my cai (that Jeff made for me) down in that area without removing the bumper bar.

 

this thread gets

 

Hmmm, no boost controller yet I see.
It's looking good.

 

Looks delightful. Congrats on the turbo.

 

looks good, are the pipes powder coated...or what method be sure to post more pictures of the final product!

 

Looking good!

Any upgrades worth mentioning??

 

yea the piping is gonna look bad *** powder coated, are all the i/c's from the greddy kit supposed to be tilted like that?

 

that's lookin' really good!
another turbo'd 8, niiiice.

 

Not yet. He has a boost gauge taped to the windshield as I'm writing this. MM is doing some tuning.

It's a High Heat Candy Blue

Not if you use the supplied Greddy intake system. That ends up in the Air Box Tray. We installed an AEM CAI and for that the intercooler must be lowered down and tilted.


Couple more pics,,,

 

very nice, love the blue
the black HKS BOV is tight too

a greddy strut bar powder coated in that same blue would look sweet too imo

 

Nice Torbo!

 

I would SO cut the Factory Airbox to fit over that part of the piping....awesome stealth potential!

 

Well that's why we at BHR are making a,,,
I can't tell you at this point in time. But it will be nice.

 

Please tell me this isn't the Greddy POS coupler!

 

oo i think it is my friend! lol should b good unless he plans on runing high boost i would assume

 

how did I miss this - looking like really sweet install guys .

 

^you were to busy worrying about injector scaling, lol.

 

how durable are those coatings? again setup looks really clean

 

All these turbo threads are going to force me to bankruptcy.

 

man you made me choke on my drink

 

Just a temporary thing until all the Samco couplers show. With the T-Bolt clamps.

I've have this same stuff on my strut bar and intake for over a year now. No fading and it can take 500 degree temps.
Don't ask what it is because I'm not going to tell you. It's top secret.

 

what if i give ya a cookie? then will you tell me? lol

 

No. But it almost worked. Send me your parts and I'll do them up for you. Red, Green, Purple, Blue.