New 2 Rotary Engine - Need Suggestions
11-26-2003, 04:29 AM
#1
Pink Slip?
Thread Starter
Join Date: Nov 2003
Location: Cerritos, CA
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
New 2 Rotary Engine - Need Suggestions
Hi Everyone,
I'm new to the Rotary world. I just got my RX-8 a week ago, and I was told by the dealer and few friends that breaking in the Rotary engine is different than Piston engine.
Are there differences? If so, what are the best ways to break in a new Rotary engine properly?
Your feedbacks are highly appreciated.
Many thanks in advance!
I'm new to the Rotary world. I just got my RX-8 a week ago, and I was told by the dealer and few friends that breaking in the Rotary engine is different than Piston engine.
Are there differences? If so, what are the best ways to break in a new Rotary engine properly?
Your feedbacks are highly appreciated.
Many thanks in advance!
11-26-2003, 04:56 AM
#2
Re: New 2 Rotary Engine - Need Suggestions
Originally posted by Koala Joe
Are there differences? If so, what are the best ways to break in a new Rotary engine properly?
Your feedbacks are highly appreciated.
Many thanks in advance!
Are there differences? If so, what are the best ways to break in a new Rotary engine properly?
Your feedbacks are highly appreciated.
Many thanks in advance!
11-27-2003, 01:02 PM
#5
Registered User
Join Date: Nov 2003
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
The dealer will usually tell you that no such break in period is neccessary. The manual says however not to push the engine to hard before the first 600 miles, It gets more specific in their, you should probably check it out.
I waited 600 on my 8, and it runs fine.
I waited 600 on my 8, and it runs fine.
Thread
Thread Starter
Forum
Replies
Last Post
Sifu
RX-8 Parts For Sale/Wanted
3
08-30-2015 10:51 PM
