Notices
RX-8 Discussion General discussion about the RX-8 that doesn't fit in one of the specialty forums.
Sponsored by:
Sponsored by: CARiD

Go, Stop, Go question

Old Apr 27, 2012 | 05:46 PM
  #1  
The Cycle Guy's Avatar
Thread Starter
Registered
 
Joined: Apr 2012
Posts: 11
Likes: 0
From: Orange County, California
CA Go, Stop, Go question

Hi, I'm new here, just bought a used 05 model.

The infamous engine flooding issue is bothering me. There sure is a wealth of information here, but in my search I could not find an answer to my particular question. I don't want to find out the hard way.

I plan to use the car on my daily rounds, which include stops at UPS and the post office. After starting the car, my usual drive is about 10 minutes to stop 1, so it will get warmed up initially. Then I usually turn off the car, get out for about 1 minute, then get back in.

Next I drive to stop 2, which is only 1 block away. This takes maybe 1 to 2 minutes. I usually stop the car again, this time for maybe 10 minutes.

During the minute I'm at stop 1, do you think the car will cool down enough so that it won't start when I'm leaving stop 2?

Do you think I should keep the car running during the minute I'm at stop 1?

Thanks for your advice.
Reply
Old Apr 27, 2012 | 06:11 PM
  #2  
ShinkaEvo's Avatar
Triangular Bee Hive
iTrader: (3)
 
Joined: Feb 2008
Posts: 779
Likes: 0
From: Socal, LA
Some ppl never have flooding issue, some do...
My advice is, simply don't turn off the car before it warms up.
Once it's warm up it's fine.

I always to go coin wash for my 8. I turn off my car for the initial wash for like 5min. (i have vented hood, so the water is going into the engine bay to cool it down as well when I wash the car, fyi) Once it's done, drive to the side to do the dry up and etc, which is only few feet away. Never had issue.
Reply
Old Apr 27, 2012 | 06:17 PM
  #3  
RIWWP's Avatar
Registered
iTrader: (2)
 
Joined: Oct 2007
Posts: 16,684
Likes: 267
From: Pacific Northwest
https://www.rx8club.com/new-member-forum-197/new-potential-owners-start-here-202454/
Information on flooding in post #2.

Including how it says that flooding is only a problem if you have weak ignition.

That being said, the needle starts moving off the bottom with the coolant passing ~100F. If the ambient temp is ~70F, it will take over an hour for the coolant to cool off that much. In freezing temps, maybe 45 minutes.


But, short story is: Just stay on top of your ignition and you can shut it off whenever you need to.
Reply
Old Apr 27, 2012 | 07:39 PM
  #4  
monchie's Avatar
I HATE SPEEDBUMPS!
 
Joined: Nov 2007
Posts: 8,549
Likes: 8
From: Las Vegas, NV
Driving the rx8 is a complicated issue, not like other cars out there.
Reply
Old Apr 27, 2012 | 07:46 PM
  #5  
RIWWP's Avatar
Registered
iTrader: (2)
 
Joined: Oct 2007
Posts: 16,684
Likes: 267
From: Pacific Northwest
Don't listen to any posts by Monchie.
Reply
Old Apr 27, 2012 | 07:59 PM
  #6  
RX8Soldier's Avatar
Time for boost...
iTrader: (24)
 
Joined: Jun 2010
Posts: 5,414
Likes: 17
From: Canada
^Thankfully, monchie is on my ignore list
Reply
Old Apr 27, 2012 | 08:01 PM
  #7  
RIWWP's Avatar
Registered
iTrader: (2)
 
Joined: Oct 2007
Posts: 16,684
Likes: 267
From: Pacific Northwest
He still shows up in Live!, and you can still see that he posted in the thread, especially if someone unwittingly quotes him.

So I don't bother with the ignore feature.

Sometimes I can counter the trouble / misinformation he spreads.
Reply
Old Apr 27, 2012 | 08:30 PM
  #8  
wcs's Avatar
wcs
no agenda
iTrader: (2)
 
Joined: Feb 2005
Posts: 5,210
Likes: 66
From: Ontario
I think you guys are too hard on Monchie sometimes
Reply
Old Apr 27, 2012 | 10:21 PM
  #9  
ken-x8's Avatar
Registered
 
Joined: Aug 2006
Posts: 5,027
Likes: 5
From: Northern Virginia
Yikes! Hard on the new guy, too. His head must be spinning by now.

Cycle guy - you'll be fine. That first 10 minute drive will get it warm. It takes hours to cool back down to cold start again. As long as the temp gauge is up to normal there's nothing to fear.

Ken
Reply
Old Apr 27, 2012 | 10:38 PM
  #10  
The Cycle Guy's Avatar
Thread Starter
Registered
 
Joined: Apr 2012
Posts: 11
Likes: 0
From: Orange County, California
Originally Posted by ken-x8
Yikes! Hard on the new guy, too. His head must be spinning by now.

Cycle guy - you'll be fine. That first 10 minute drive will get it warm. It takes hours to cool back down to cold start again. As long as the temp gauge is up to normal there's nothing to fear.

Ken
Thanks Ken and everyone else, that's what I wanted to hear. My RX8 should make a neat little package delivery vehicle.

My head isn't spinning, not yet anyway. I'm a veteran of a couple of motorcycle forums, and wow you should see how those guys carry on!
Reply
Old Apr 27, 2012 | 10:55 PM
  #11  
tcole6's Avatar
Registered
 
Joined: Apr 2010
Posts: 316
Likes: 0
From: NJ
It will be a neat little delivery vehicle until you see that you'll get about 14 mpg But hey, you'll look cool doing it!
Reply
Old Apr 28, 2012 | 12:02 AM
  #12  
monchie's Avatar
I HATE SPEEDBUMPS!
 
Joined: Nov 2007
Posts: 8,549
Likes: 8
From: Las Vegas, NV
Originally Posted by RIWWP
Don't listen to any posts by Monchie.

Yes, please don't...

Originally Posted by RX8Soldier
^Thankfully, monchie is on my ignore list

Thanks for doing that...

Originally Posted by RIWWP
He still shows up in Live!, and you can still see that he posted in the thread, especially if someone unwittingly quotes him.

So I don't bother with the ignore feature.

Sometimes I can counter the trouble / misinformation he spreads.

Thanks for saying that...

Originally Posted by wcs
I think you guys are too hard on Monchie sometimes

I don't know you, but thanks for backing me up...
Reply
Old Apr 28, 2012 | 07:14 AM
  #13  
New Yorker's Avatar
Registered
 
Joined: Sep 2003
Posts: 3,319
Likes: 58
From: NYC
Once your engine reaches normal operating temperature (in other words, after you let it run or drive a few minutes) the engine is warm and will stay warm unless you let it sit for hours, not minutes. So no worries for you.
Reply
Old Apr 28, 2012 | 07:49 PM
  #14  
Loki's Avatar
Registered
iTrader: (1)
 
Joined: Jun 2009
Posts: 8,389
Likes: 1,109
From: Montreal
Make sure you've had the latest computer update (they're supposed to do it whenever the car is brought in for service, but make sure). With old 2004-vintage software this was an issue, anything since 2007 shouldn't be a problem. It's not worth stressing about, just enjoy the car and remember the de-flood procedure just in case. It's in the manual.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
RevMeHarder
New Member Forum
7
Jul 12, 2025 07:22 PM
DVerdeyen
Series I Trouble Shooting
6
Sep 13, 2015 11:19 AM
TJSiegrist
New Member Forum
9
Sep 10, 2015 09:29 AM
stickmantijuana
Series I Wheels, Tires, Brakes & Suspension
0
Sep 4, 2015 10:31 PM
Rupanrx
Series I Aftermarket Performance Modifications
1
Sep 4, 2015 06:44 AM


Thread Tools
Rate This Thread
Rate This Thread:
You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 11:05 PM.