Can't post in the tech section, which makes total sense because I'm new here, so I must be an idiot. Got my jdm replacement 13b last night, looks good overall, but the clowns cut some wires and I can't find this one in a diagram, original harness from original engine was pulled and engine was completely torn down by previous owner when I got the car, so I have no reference. Anyone know what this is?

 

How about a photo from a little farther away showing the pins of the connector.

 

so the connector side goes in the driver's side fuse box, that's not a problem, but I can't figure out where on the engine the cut end would go. I found the other end of the wire on the original harness, it's all cracked apart and filled with what looked like white lithium grease. I can take a picture later. Also, they destroyed the connector that connects to the oil level sensor(?) In the oil pan, and like an idiot I de-pinned the one off of my old harness, thinking as I've re-pinned connectors before, I could just slap my old connector on my new harness no problem. Well I suck at it apparently, and totally boogered the pins up. Anyone know where I can get a pigtail connector so I can just solder it in? Part number? Place to find a part number?
It resembles the one in the picture closely, with the steel retaining wire, but this one is an injector connector.

 

So the blue wire with a red stripe is the starter solenoid wire apparently. But I don't know how I'm going to put that connector on if I can even find one.