LMnsr

Hello everyone,

I am new here just sold my r33 skyline a few months back and kept my 04 AT rx8.
I am going to be converting it into my new drift car with a FI 13brew bridgeport. (please I'm not saying that to get bashed, and I am not one of those dreamers about doing the swap as some say)

I am going for my handling first. I'm not going to post all the things I'm getting for it since I'll be saving that for when I actually have them and get approved to start a thread in the correct topic.

I'm getting coilovers control arms, tie rods etc the basics..
What I'm trying to figure out with this post is what wheel offset I should use (Especially in the front for rubbing after I mod my knuckles/arm).

I will be going with 18" wheels 8.5 front and 9.5 rear.
I'm pretty sure I'm going to have to roll my fenders and might pull them until I get some wider fenders, but looks is last for me at the moment..

Any advice would be greatly appreciated

Thanks

dannobre

iTrader: (3)

18X9.5 +35 fits without any major work front and back depending on tires. Anything less than that and you start to have issues with the outside( fenders rub)

LMnsr

Thanks for the reply