so I put new plugs and wires and coil packs on my 8 and it ran fine for about 3 months then cuts off with no cell just replaced crank sensor and now when I start it it skips cranks and then just turns went through deflood process and it wants to ctach but doesn't its 2004 rx8 6 speed got it this year with 60000 miles and just broke down no mods done expect toyo sport catback exhaust

 

That's one long sentence.... What do you mean by "skips cranks"? Have you performed a proper rotary compression test yet? If not, you need to. It would benefit you to get the engine running for so that its at normal operating temperature when you do the compression test. This will give you the most accurate numbers. When you unflooded the engine, what method did you use? Did you clean the plugs thoroughly, pull the 20A fuel pump fuse, move the wires to a safe spot and crank the engine with the plugs out to blow the excess gas out of the engine?

 

 

pulled out plugs and unplugged crank sensor and finally got a code p0336

 

When you change the eccentric shaft position sensor, you need to do the 20-time brake pedal procedure. Google it.
The sensor needs to be learned by the computer, and it's very possible that it's misbehaving because it still thinks it has the old sensor.

The P0336 is the code for when the eccentric shaft sensor is unplugged Can't run the engine if it doesn't know where it is in the revolution.

 

And it's for their own benefits, too.

Can't help if I can't understand you.



Anyway, if your ignition works, I'd then check for fuel pressure and make sure the engine is getting fuel.