I just swapped my renesis for another renesis and everything is working fine until 6000 rpm then the engine goes to limp mode and the code it gives is p0336 (Eccentric shaft positioning sensor). I clear the code but it always comes back at 6000 rpm.

-I sandpapered the main ground underneath the battery box
-replaced the eccentric shaft sensor
-did the 10 brake presses in 10 sec with oil gauge going to half and then down
-replaced spark plugs

 

What does your e-shaft position plate look like? This thing:


EDIT:
Also, 6k is where the rotary starts opening some of the valves. Something weird might be happening.

 

It's OEM, is there only one way to put it on, or do I need to reorient it? It starts up, idles, and runs fine but it's just at 6000 rpm.