Microtech LT16 idle map
#1
New Member
Thread Starter
Microtech LT16 idle map
Hi Team,
I have seached the threads but can seem to find any figures.
I go the ECU off a mate was a piggy back to his PCM sent it to off to a vendour for some conversion to run as a stand alone , got it back swings but wont start.
Geen light on
Orange flashes while cranking.
Got power to the coils fuel pumps running , battery is charged , tested leads and plugs etc sheswings but no burn.
i think he messed with the maps when tuning his Rx , so im after a basic idle map if anyone is willing to share in the hopes i can get it started then tune from there.
see the rx7 boys did a step by stem for the LT10 ... not sure if it would be simlar ?
I have a 13b standard motor
Std coils 3 wire
Std injectors
92mm Throttle body
Water temp
Air temp
any help would be appreciated thanks in advance.
I have seached the threads but can seem to find any figures.
I go the ECU off a mate was a piggy back to his PCM sent it to off to a vendour for some conversion to run as a stand alone , got it back swings but wont start.
Geen light on
Orange flashes while cranking.
Got power to the coils fuel pumps running , battery is charged , tested leads and plugs etc sheswings but no burn.
i think he messed with the maps when tuning his Rx , so im after a basic idle map if anyone is willing to share in the hopes i can get it started then tune from there.
see the rx7 boys did a step by stem for the LT10 ... not sure if it would be simlar ?
I have a 13b standard motor
Std coils 3 wire
Std injectors
92mm Throttle body
Water temp
Air temp
any help would be appreciated thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
thewird
Series I Engine Tuning Forum
7
09-12-2009 07:01 AM
thewird
Series I Engine Tuning Forum
0
09-04-2009 07:31 PM
pcimino
Series I Interior, Audio, and Electronics
2
01-27-2006 08:12 PM