Hey guys, new to the forum and rotaries in general. I just picked up a motor out of an RX-8 to swap into a little MGB project I have going. It's in a few pieces though, and needs a hand full of replacement parts I'm having a hard time finding the name of.
My two main concerns right now are what appears to be a vacuum distribution block, the black part here:


And this little bitty bolt that goes to the intake. One was there, one appears to be snapped off and missing.



Most of what I've needed to know so far I've been able to find through search, but I'm sure this won't be the last time I have an odd question. Thanks in advanced to anyone that reads this.

 

You planning on using the Aux Port Valves? The barrels are missing as well. You won't need that bolt if you aren't using the valve. What are using for an ECU? If you dont have a way to actuate the valve it's a moot point anyway

 

I assume I should use them. I have the barrels, they're both in that picture actually. Knowing that they're called aux port valves helped me find the bolt I'm after. Part # N3H6-13-B65 in case anyone else is ever looking.
I'll be using the stock ECU to control everything.

 

if you come across anything you need hit me up, i have a part out thread with a lot of stuff sitting in my garage

 

Vacuum block on the intermediate housing is to provide vacuum to the oil metering injectors. That one is broken. If you aren't using the OMP system, it can be removed, otherwise you'll need a new one.