Help please. 2009 r3 model 45000km
#1
Help please. 2009 r3 model 45000km
I'm freaking out my r3 model 2009 with 45000 was working fine and now it randomly started becoming jerky and loosing power and pull at around 7k the engine light started flashing now it's on solid. I've got a mazda speed intake that goes pretty low and the oil was over filled by about a half quart. Could it be maf related or is my cat clogged?
#3
Water Foul
A flashing CEL is a misfire. If you have not replaced your coils, wires, and spark plugs by 45K, you need to do it now. You also need to have the cat inspected. If you have been suffering misfires, it may be failing, which in turn may damage the engine. These are all part of the cascading failure cycle that starts with bad coils.
If the oil was overfilled, you need to check the intake and throttle body for oil and clean it out if needed. You should also clean the MAF with contact cleaner.
Knowing the code that is causing the CEL would be helpful in troubleshooting as well.
If the oil was overfilled, you need to check the intake and throttle body for oil and clean it out if needed. You should also clean the MAF with contact cleaner.
Knowing the code that is causing the CEL would be helpful in troubleshooting as well.
Last edited by Steve Dallas; 06-02-2015 at 01:23 PM.
#4
Light flashing = misfire. I would check your coils, plugs, etc. I believe your plugs could also be fouled from overfilling your oil.
My 05 had a similar issue where my car would hit a wall at 7K RPM and then had a misfire. I changed my coils, wires, plugs and everything was fine after.
My 05 had a similar issue where my car would hit a wall at 7K RPM and then had a misfire. I changed my coils, wires, plugs and everything was fine after.
Thread
Thread Starter
Forum
Replies
Last Post
pdxhak
General Automotive
7
09-22-2015 07:39 AM
vetteor8
New Member Forum
3
08-09-2015 05:56 PM