Can someone PLEASE help me install this Saterday or tonight. PLease HELP...

 

In the tri state area.

 

umm what are you installing would be good
and I am working on my s2k again tomorrow
cel o2 sensor and damn door speaker keeps getting loose

 

from the picture it seems as though you're installing:
- RB gauge pod
- 3 gauges in pod
- Oil adapter with sending units
- Coolant adapter with sending unit
- Vent Pod Gaguge
- Additional gauge


This is probably better done tomorrow since it's not exactly a quick job. Good luck, hopefully someone in your area can help. If you need help with grounding / running some of those wires check out my sticky thread

 

^Thanks jedi....

The gauges are:

oil temp
oil pressure
water temp
volt

I have a boost for when i go turbo, but i want to install these for now before DGRR.


If I had a shop do how much do you guys think they would charge???

 

def we could do it together, but hopefully some one can come by to help with the gauges. This will be a 1st for me. I could return the favor, I have a uncle with a body shop, and i can do general mechanic work...

 

omar i can help you saturday night or wednesday night.....saturday i gotta do laundry and go food shopping after that im good

 

I spoke to u on the phone chris so u know the deal...

 

yeah we set.....ill call you tomorrow afternoon

 

id help but i have my own headaches to sort out before deals.. goodluck

 

your welcome to come up benny.....

 

lol re-read my prevous post but thanks for the offer

 

Sarcazum!!!!!!!!!!!!

lmao

Benny will come to u at 3am lol jk

 

you know my garage is open!

 

You're probably going to have to remove the oil temp sensor from the fitting until after you tighten the filter bolt on. It won't turn with the temp sensor installed. At least it didn't on mine.

 

id help if i knew how lol. but im not up to that yet on my car. hope everything goes smoothly.

 

i got them all in and on but it looks like 2 of the guages are malfunctioning....oil pressure is working and volts....but water temp, and oil temp crapped out.....

 

I'll be at my garage for a bit today if you wanna have meet look at them. I don't have a ton of free time -but I'll see what I can do.

Just hit me up Omar, I headed there in about 30min.

 

omar is on his way to south carolina.....he wont be back till tuesday.....getting his car registered and licence

 

ahhhh h OK

 

[QUOTE=NYC Drift King;2961898]Can someone PLEASE help me install this Saterday or tonight. PLease HELP...


saterday??? or is it saturday...

 

I'm in SC right now.

 

get the car handled and get back!

 

chris: what were the gauges doing?
where were they grounded?
Could it be a bad sending unit?

 

the guages all shared ground and power so they all powered up just fine.....the oil temp and water temp didnt work but the oil pressure did.....the senders looked fine and i tested them by grounding each individually and nothing so it wasnt the sender being wrapped in too much teflon......all the wires were brand new.....only assumption left was bad guage or bad sender....either way he needs 2 new guages