Can someone PLEASE help me install this Saterday or tonight. PLease HELP...
#4
Administrator
iTrader: (7)
from the picture it seems as though you're installing:
- RB gauge pod
- 3 gauges in pod
- Oil adapter with sending units
- Coolant adapter with sending unit
- Vent Pod Gaguge
- Additional gauge
This is probably better done tomorrow since it's not exactly a quick job. Good luck, hopefully someone in your area can help. If you need help with grounding / running some of those wires check out my sticky thread
- RB gauge pod
- 3 gauges in pod
- Oil adapter with sending units
- Coolant adapter with sending unit
- Vent Pod Gaguge
- Additional gauge
This is probably better done tomorrow since it's not exactly a quick job. Good luck, hopefully someone in your area can help. If you need help with grounding / running some of those wires check out my sticky thread
#15
The Chief
iTrader: (7)
Join Date: Jun 2005
Location: Virginia Beach, VA
Posts: 827
Likes: 0
Received 0 Likes
on
0 Posts
You're probably going to have to remove the oil temp sensor from the fitting until after you tighten the filter bolt on. It won't turn with the temp sensor installed. At least it didn't on mine.
#17
Misfit Moderator TnC
i got them all in and on but it looks like 2 of the guages are malfunctioning....oil pressure is working and volts....but water temp, and oil temp crapped out.....
#18
Just hit me up Omar, I headed there in about 30min.
#24
Administrator
iTrader: (7)
chris: what were the gauges doing?
where were they grounded?
Could it be a bad sending unit?
where were they grounded?
Could it be a bad sending unit?
#25
Misfit Moderator TnC
the guages all shared ground and power so they all powered up just fine.....the oil temp and water temp didnt work but the oil pressure did.....the senders looked fine and i tested them by grounding each individually and nothing so it wasnt the sender being wrapped in too much teflon......all the wires were brand new.....only assumption left was bad guage or bad sender....either way he needs 2 new guages