Rotary13b1 - and a quick accent question
02-25-2007, 09:28 AM
#1
Book em' Dano
Thread Starter
Join Date: Oct 2006
Location: Smyrna, GA
Posts: 797
Likes: 0
Received 0 Likes
on
0 Posts
Rotary13b1 - and a quick accent question
Good guys and a good deal.
Front and Rear rotary accents shipped for 70$ and were here in 3 days. (Not plastic - Aluminum and front is heavier than I expected).
Only question I had was no "pegs" for the front accent. Really important or not so much? and any thoughts on a "substitute" for them?
Front and Rear rotary accents shipped for 70$ and were here in 3 days. (Not plastic - Aluminum and front is heavier than I expected).
Only question I had was no "pegs" for the front accent. Really important or not so much? and any thoughts on a "substitute" for them?
02-27-2007, 08:17 PM
#3
Registered User
Join Date: Jan 2007
Location: Bradenton, Florida
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
My opinion on the pegs for the frony accent is that they are not needed. If you used the 3M wipe and adhesive strip, the accent isn't going anywhere. Actually, the plastic pegs are kind of flimsy anyway.
03-22-2007, 04:25 PM
#5
Kinda late in the response, but like others have stated... You really don't need the X-Mas Tree clips to hold the front accent onto the front. I did some extensive researching and I really believe the 3M VHB tape does the job quite well.
Thread
Thread Starter
Forum
Replies
Last Post
Rupanrx
Series I Aftermarket Performance Modifications
1
09-04-2015 06:44 AM