Oil sender in this location
#4
What am I doing here?
Join Date: Mar 2006
Location: 2017 Miata RF Launch Edition
Posts: 3,606
Received 649 Likes
on
510 Posts
I used a pair of banjo bolts that were drilled and tapped with 1/8th NPT fittings. For temp I used a normally used for EGT in the bolt on the front cover (before the oil coolers in the flow path) and connected it to an
so I could read/display it with an Arduino and a 20x4 LCD display. For pressure I used a
that outputs 0-4.5V connected to the banjo bolt where the cooled oil re-enters the engine. Again, connected to my Arduino.
Thread
Thread Starter
Forum
Replies
Last Post