Phil_Hendrie_is_back
08-27-2007, 12:17 AM
I'm wondering if someone can advise me on this issue. My car is over 80,000 miles (with no previous engine issues) and I'm on original spark plugs aside from the recall that changed the leading spark plugs. I know it's been way too long so please no flaming because I had the recall plugs done at over 50,000 miles and I had assumed all 4 were changed. I recently found out that only the leading ones are changed.
Saturday, my car sputtered at a stop light and the check engine light went on for a split second. I eased it into parking lot, stopped the engine for about 2 minutes, restarted, and everything was fine. Earlier today, it happened again and everything was fine after I restarted the car. But at about 8 pm tonight, I was trying to get onto a fwy on-ramp with a slight incline and it sputtered badly and the check engine light came on but didn't go off. I had to take it to the next offramp and take side streets back home for about an estimated 3 miles. I went as high as 3rd gear and between 25 and 35 mph. At times it was so rough that it seemed like only one rotor was running.
Could spark plugs that are worn out do this? Is this essentially detonation? Can it damage my engine? What are the chances my engine is ok? Should I just go ahead and have the dealership install new spark plugs? If so, what would the cost be (plugs + labor)? Since I could risk damage driving my car to the nearest mazda dealership, would you guys advise me to mail-order the plugs for cheap at sparkplugs.com and install it myself?
If I install the plugs myself, would a regular spark plug wrench set work fine or is there a special tool for the RX8 plugs? A friend of mine said I may want a dealership to install the plugs because really old plugs can get brittle and there is a chance I can break the ends off while trying to unscrew them. Is this true?
Thanks in advance.
***Edit: I failed to mention that 2 months ago, my engine started requiring about 4 cranks before starting (instead of the usual 2). Now it's more like 5 cranks to start. The starter is strong though. Two weeks ago, I brought my car in to repair a flat tire and the service guy told me I need new spark plugs. He was pretty sure it was the plugs.
***Final Update: Problem Solved!!!!!
Monday morning I had a dilemma. I wanted to drive my car to a certain Mazda dealership that matched Rosenthal Mazda's price of $110 for four spark plugs (sparkplugs.com is still cheaper at $80 for four but I couldn't wait. Other dealerships were way more expensive than Rosenthal and refused to go lower.). However this dealership wanted an hour and a half for labor, which is a rip-off. Another dealership offered me a half hour for labor. My plan was to buy the plugs at the first place and get them installed at the second place. The problem was AAA would only cover the first 7 miles for towing; the first place was 16 miles away and the second place was 30 miles away. So what I did was take a chance and drove my car clunking around side-streets on basically one rotor and 25 to 35 mph for 9 miles in order to get within 7 miles of the first dealership, at which point I called AAA and they came and towed my car to the first dealership. At that dealership, I decided not to risk damaging my car any more and so I accepted their exorbitant labor cost. The technician reiterated what nycgps had told me: it probably wouldn't hurt the engine but might hurt the catalytic converter. So thanks again to nycgps, he was right on, which is why I even made the strategic decision to drive the 9 miles in the first place. The technician said that the back rotor was completely shut down, the plugs were really dirty, but it wasn't so much the spark plugs as it was the ignition coils for the back rotor were fried. The tech said I needed two new coils so I figured he wasn't lying (and I would have to replace them soon anyway) so I decided to purchase all four, but only after the parts guy agreed to beat Rosenthal Mazda ($29 per coil instead of Rosenthal's $30 per coil). Oh, and he added a half hour of labor. I'm glad to report that my car is running and revving better than ever. The tech did tell me that there is a chance that the cat was messed up, but I believe it's ok after driving the car all afternoon. I did not however buy the spark plug wires/leads and the tech did not try to sell me those. One last thing is that while clunking the engine for around 15 miles over the last two days on one rotor went from the beginning of the LAST QUARTER of my gas tank to when the light came on (that's right about when I parked the car and waited for the tow truck)! Usually, I can drive 40 miles on the last quarter before the light comes on. So a TON of gas must have been dumped into the cat. Just for swoope's sake, the tech's conclusion was that the plugs were shot AND the two coils for the rear rotor were also shot.
But anyway, my calculated risks paid off and it was only because of the sound information given to me by this forum, namely nycgps!
Saturday, my car sputtered at a stop light and the check engine light went on for a split second. I eased it into parking lot, stopped the engine for about 2 minutes, restarted, and everything was fine. Earlier today, it happened again and everything was fine after I restarted the car. But at about 8 pm tonight, I was trying to get onto a fwy on-ramp with a slight incline and it sputtered badly and the check engine light came on but didn't go off. I had to take it to the next offramp and take side streets back home for about an estimated 3 miles. I went as high as 3rd gear and between 25 and 35 mph. At times it was so rough that it seemed like only one rotor was running.
Could spark plugs that are worn out do this? Is this essentially detonation? Can it damage my engine? What are the chances my engine is ok? Should I just go ahead and have the dealership install new spark plugs? If so, what would the cost be (plugs + labor)? Since I could risk damage driving my car to the nearest mazda dealership, would you guys advise me to mail-order the plugs for cheap at sparkplugs.com and install it myself?
If I install the plugs myself, would a regular spark plug wrench set work fine or is there a special tool for the RX8 plugs? A friend of mine said I may want a dealership to install the plugs because really old plugs can get brittle and there is a chance I can break the ends off while trying to unscrew them. Is this true?
Thanks in advance.
***Edit: I failed to mention that 2 months ago, my engine started requiring about 4 cranks before starting (instead of the usual 2). Now it's more like 5 cranks to start. The starter is strong though. Two weeks ago, I brought my car in to repair a flat tire and the service guy told me I need new spark plugs. He was pretty sure it was the plugs.
***Final Update: Problem Solved!!!!!
Monday morning I had a dilemma. I wanted to drive my car to a certain Mazda dealership that matched Rosenthal Mazda's price of $110 for four spark plugs (sparkplugs.com is still cheaper at $80 for four but I couldn't wait. Other dealerships were way more expensive than Rosenthal and refused to go lower.). However this dealership wanted an hour and a half for labor, which is a rip-off. Another dealership offered me a half hour for labor. My plan was to buy the plugs at the first place and get them installed at the second place. The problem was AAA would only cover the first 7 miles for towing; the first place was 16 miles away and the second place was 30 miles away. So what I did was take a chance and drove my car clunking around side-streets on basically one rotor and 25 to 35 mph for 9 miles in order to get within 7 miles of the first dealership, at which point I called AAA and they came and towed my car to the first dealership. At that dealership, I decided not to risk damaging my car any more and so I accepted their exorbitant labor cost. The technician reiterated what nycgps had told me: it probably wouldn't hurt the engine but might hurt the catalytic converter. So thanks again to nycgps, he was right on, which is why I even made the strategic decision to drive the 9 miles in the first place. The technician said that the back rotor was completely shut down, the plugs were really dirty, but it wasn't so much the spark plugs as it was the ignition coils for the back rotor were fried. The tech said I needed two new coils so I figured he wasn't lying (and I would have to replace them soon anyway) so I decided to purchase all four, but only after the parts guy agreed to beat Rosenthal Mazda ($29 per coil instead of Rosenthal's $30 per coil). Oh, and he added a half hour of labor. I'm glad to report that my car is running and revving better than ever. The tech did tell me that there is a chance that the cat was messed up, but I believe it's ok after driving the car all afternoon. I did not however buy the spark plug wires/leads and the tech did not try to sell me those. One last thing is that while clunking the engine for around 15 miles over the last two days on one rotor went from the beginning of the LAST QUARTER of my gas tank to when the light came on (that's right about when I parked the car and waited for the tow truck)! Usually, I can drive 40 miles on the last quarter before the light comes on. So a TON of gas must have been dumped into the cat. Just for swoope's sake, the tech's conclusion was that the plugs were shot AND the two coils for the rear rotor were also shot.
But anyway, my calculated risks paid off and it was only because of the sound information given to me by this forum, namely nycgps!