Stalling
Thread Starter
Registered User
Joined: Feb 2006
Posts: 17
Likes: 0
From: Clermont, Florida
Stalling ALL the time now!!!!
I have an AT which keeps stalling on me when I'm at idle. New spark plugs, new coil packs, had the battery and alternator tested.... I just recently started getting a misfire on cylinder 1 CEL. Help please. I stalled 4 times within an hour.
Last edited by precisi0n84; Feb 20, 2007 at 06:52 PM.
Registered
Joined: Jul 2004
Posts: 2,598
Likes: 3
From: Fayetteville, PA
What mods have you made to the car? What year car? How do you know you're getting a misfire? Is it a random occurance?
Probably time to head to a dealer for diagnosis. I hope you have a competent service department at a dealer near you. Make sure they check the engine compression and show you the results.
Probably time to head to a dealer for diagnosis. I hope you have a competent service department at a dealer near you. Make sure they check the engine compression and show you the results.
II SOCIETY
Joined: Nov 2006
Posts: 1,077
Likes: 0
From: The Bay Area
Originally Posted by precisi0n84
...I just recently started getting a misfire on cylinder 1CEL. Help please. I stalled 4 times within an hour.
Last edited by Phantom Menace; Feb 23, 2007 at 01:23 PM.
the WANKEL made me do it
Joined: Apr 2005
Posts: 317
Likes: 0
From: Pittsburgh
^hmmm. he's using a generic scanner p0301 is cylinder 1(front rotor) p0302 is cylinder 2 (rear rotor) P0300 is a random/multiple cylinder misfire
PrecisiOn84, Do you have a flashing CEL that goes away or a solid one?
Did you reset your eccentric shaft position memory?
http://www.finishlineperformance.com...30-05-1544.pdf
PrecisiOn84, Do you have a flashing CEL that goes away or a solid one?
Did you reset your eccentric shaft position memory?
http://www.finishlineperformance.com...30-05-1544.pdf
II SOCIETY
Joined: Nov 2006
Posts: 1,077
Likes: 0
From: The Bay Area
Originally Posted by Mazda-Rati
^hmmm. he's using a generic scanner p0301 is cylinder 1(front rotor) p0302 is cylinder 2 (rear rotor) P0300 is a random/multiple cylinder misfire
PrecisiOn84, Do you have a flashing CEL that goes away or a solid one?
Did you reset your eccentric shaft position memory?
http://www.finishlineperformance.com...30-05-1544.pdf
PrecisiOn84, Do you have a flashing CEL that goes away or a solid one?
Did you reset your eccentric shaft position memory?
http://www.finishlineperformance.com...30-05-1544.pdf
Thread
Thread Starter
Forum
Replies
Last Post
Brooklynite
NE For Sale/Wanted
4
Nov 10, 2015 06:42 PM