Category: Drivetrain
Price: $12000
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): Others, Series I, Series II
Location (US State/Canada/Int): KS
Item Condition: Used

I purchased an RX-8 race car built by Louie and Tony Rivera. I am going to use the drive train from my RX-7 so I have the following items available. This is perfect for somebody with an RX-8 roller.. plug and play. Top of the line everything.

- Luis Rivera built motor with ceramic apex seals, 5 hours on motor since refreshed by Kan Tuning.

- Motec M-800 ECU. Tuned for existing motor.

- Motec ADL Dash.

- Wire harness for MoTeC, and ADL dash

- Racing Beat intake.

- New (one dyno run) Mazda Series II, 6-speed transmission with new shifter & throw out bearing

- One race weekend on 5.11 differential with OE limited slip (REM treated) set up by Jesse Prather Motorsports

- Tilton 5.5” clutch, with new, disks, floater and pressure plate.

- New lightweight aluminum racing flywheel.

- Black Halo Racing coils.

- Racing Exhaust (header, mid pipe, muffler)

- Drive shaft

I'd like to sell as a complete package but will part out if there are no takers.

Feel free to call.

Thanks,

Steve Smyczek
414-339-5084

 

Sent you a PM

 

Alan, I did not get the PM

Steve

 

Re-PM'd

 

pictures would help out a lot!

 

Hard to see the REM treated 5.11 ratio


5 hrs on rebuild


Rebuilt Trans, new clutch, flywheel


MoTeC M 800 already tuned for engine, complete wire harness in box


MoTec ADL Dash 3.20d is the software rev. . I bought a Motec GPS setup but never used it, you get that too.


Exhaust including header


Racing Beat Intake