I have a stalled 20B conversion project with my 1993 RX7. I will sell the early spec JDM Cosmo engine for $3500. I also have all the other major components available to make a 550+ WHP RX Dream. All top quality race proven manufacturers and no Chinese junk. I will sell the entire project including the clean 1993 RX7 if interested. It needs very little to complete besides having the drive shaft shortened. $17,500. If you are serious PM me because I check my email often. Please only serious buyers!

 

The drive shaft will not be the same length as stock because the engine was moved back about 1 1/2 inches. The engine cradle and oil pan are made with proprietary information that the new owner will get but it allows for hood clearance. I have coils, ACT 6 puk sprung clutch and I believe a 13lbs. flywheel ( I can't recall and have not found the receipt) New and modified RX7 engine mounts, Wolf 30 4.0 plus, Aeromotive pump 11101, filter 12304,element 12604, modified fuel pick up system, regulator 13109, hoses, fittings, lines etc... Marren injectors 3each 0585PI, 3each 0585, Mazda trix downpipe modified, JGS 60mm billet wastegate TK289, JGS 340 billet BOV TK195, Koyo 3 row radiator, battery relocated, Garrett blowzilla turbo, not certain if the intercooler plumbing will have to be changed. Tien coil overs, Kaaz LSD, ASA 18" rims. I'm sure I have over looked some stuff. My fabricator used to build my race cars in IMSA and developed GTP cars. He is a master and has over 2 decades of fabricating experience. I will not part out the car except to sell the 20B in "as purchased" from the importers condition.

Sorry guys but I'm old school. I have not had much luck with the treads so I put less information hoping interested parties will PM for specifics on a follow up phone call . I appreciate your post 8 Maniac. I have been inundated with PM's from kids, dreamers, time wasters and yoyos. The most recent PM I received asked if the $3500 motor was new? In my response to him I suggested he do some homework. My intent was to be constructive and efficient, sorry if I offended you. I get email notifications when I have a PM so please contact me that way to start a dialog. The last 3 rotor FD that sold at Barrett Jackson brought over $50000. There is plenty of time to finish this car and have fun with it before making a few bucks.

Thank you.

 

I forgot to mention this. If you have a RX8 and want to do a 20b swap I would be willing to sell all the parts I have collectively for your conversion, minus the RX7 specific stuff. I am not interested in doing a you pick and choose garage sale kinda deal.

 

Hey thanks for the confirmation! I have comfortably over 20k hard cash with numerous parts bought at wholesale direct from suppliers. That number does not reflect one penny for the fabrication. Somebody can save a honest 5 to 10 grand at my expense. If I get ann offer on one of my kids first I'm keeping the car.

 

bump