rotor_man

I have just purchased the RB ram air duct and am going to make an adaptor out of fiberglass to join this to the stock air box.

If someone out there has changed their intake to an aftermarket and still has the stock one lying around could they do me a favour.

What i would like is if you could trace on a piece of paper around where the airbox outlet joins the VFAD then scan the picture and post it or email it to me.

I really would appreciate it as it will enable me to make the adaptor prior to installing the RB duct and do the whole install at once.

Moderators i'm not sure if this is in the right section so feel free to move
thanks