{ FS } (2) Status Racing Seats NIB
#1
(2) Status Racing Seats NIB
Category: Accessories
Price: $1800
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): Series I, Series II
Location (US State/Canada/Int): PA
Item Condition: New
(2) NEW IN BOX Status Racing Ring seats made of alcantara
(2) NEW IN BOX OMP Seat Rails
(2) NEW IN BOX Status Racing Side Mounts
All you need is seat bases and hardware to mount the side mounts to the seat bases.
Status Racing builds each order by hand and does not maintain a stock of seats. Everything is built to order and then shipped from the west coast. I had to wait over a month to get these seats and pay for shipping.
Both seats with all the hardware mentioned above is a bit over 60lbs. If you have a GT your leather seats are ~120lbs.
My loss is your gain. I paid $2500 for these seats, I'll let them go for $1800. Price is firm. I still have the original packaging these seats came in, but shipping will be expensive since it is a big freaking box.
Here they are sitting in their original packaging:
NE FS Thread
#4
Pics of FIA sticker, please?
And in the second picture I see a seat base, so do you mean the only thing you don't have is sliders?
BTW, these seats are the skinny seats for 32-33" waist only, right?
And in the second picture I see a seat base, so do you mean the only thing you don't have is sliders?
BTW, these seats are the skinny seats for 32-33" waist only, right?
#5
yup, these are the RING seats which are 32-33in waist.
I have the sliders, they are OMP but they are not FIA approved sadly.
They are missing the hardware that bolts the side mounts, seat rails, and seat bases together. I contacted status several times and i got not answer. Now my motor is trashed and i need these seats gone so i can get my car back on the road.
I'll get a pic of the sticker when i get home.
I have the sliders, they are OMP but they are not FIA approved sadly.
They are missing the hardware that bolts the side mounts, seat rails, and seat bases together. I contacted status several times and i got not answer. Now my motor is trashed and i need these seats gone so i can get my car back on the road.
I'll get a pic of the sticker when i get home.
#13
Pretty sharp looking seats. You RX-8 guys have a bit of an easier time fitting aftermarket seats..... in the FD RX-7 they're very tight and barely any of them fit without giving problems rubbing the door panels or the trans tunnel.
Where in PA are you located?
Where in PA are you located?
#17