Working on a summer project. Decided to make these and i liked how they turned out so i'm gonna offer them to you.

I haven't decided where to place them yet, but i think i'm going to put the RX-8 Logo on the lighter/ashtray cover!

They look good. Check them out in the Parts for sale forum!!

 

Oh, i forgot to mention...

These are laser cut, brushed stainless steel... so they won't rust!!

Good for any application anywhere, on anything!! the badges look great IMO, tell me what you guys think. They're for sale

 

Looks good.. but what is the price? If the price isn't higher than the authentic MS badges, I'm sure you could sell quite a bit of these.

 

Be careful,not sure what the laws are but I'd bet that "rx-8" and "mazdaspeed" are trademarked and copywrited by Mazda.

 

damn you post a lot of **** that doesn't belong in this section of the forum...

 

sorry maddog... i don't know any better!!
but it's for appearance, and .. ****... i meant to post in the appearance!! sorry about that!

HERE is the link for the FS thread: https://www.rx8club.com/violations-53/fs-custom-badges-ms-rx-8-any-application-63662/

 

If somebody could make a rotary badge, I'd be all over it. I'm always looking for more ways to put more triangles on my RX-8. :D

I'm kinda surprised nobody makes a license plate frame that says "Rotary Powered" surrounded by rotary icons or something to that effect.

 

If you guys want, find me a logo that you guys would be interested in. I'll see if i can make it happen... Images images images!!

 

Well i'm partial to the efini emblems, i always wondered how they'd look on an 8. Heres's a pic of them: efini badges

 

https://www.rx8club.com/showthread.p...0&page=4&pp=15

Scroll down a bit after you open it.

 

can they be cut in some kind of colored material?

 

you can always paint them...? I think the production cost would be too high if the material is dyed. Just get some automotive paint, and spray them -- i bet the results would be better...