REPLACE YOUR PURGE VALVE SOLENOID ASAP...Drives like new
Registered
Joined: May 2025
Posts: 3
Likes: 0
Your TB spray trick worked like a charm. Barely had to spray any down there, and it worked through instantly. It popped off so easy after and didn't break anything pulling it out. Thank you!
+5 on this!
I was having the same issue where my clutch felt weak on take off. I bought the part and installed it. It wasn’t easy as the space is limited and the part was seized on there. I took out the vacuum line up top (shaped like an U) and sprayed throttle body cleaner through the hole hoping the nipples and the rubber seals would absorb it to lube up removing them. It seemed to work since I was able to wiggle them out and the nipples bad liquid from the TB cleaner spray. Putting them back was tricky as you have to slide them in while pushing down on the lower intake which has a bit of movement to allow the part to go in. I took the car for a spin and acceleration seems better and smoother than before.
I was having the same issue where my clutch felt weak on take off. I bought the part and installed it. It wasn’t easy as the space is limited and the part was seized on there. I took out the vacuum line up top (shaped like an U) and sprayed throttle body cleaner through the hole hoping the nipples and the rubber seals would absorb it to lube up removing them. It seemed to work since I was able to wiggle them out and the nipples bad liquid from the TB cleaner spray. Putting them back was tricky as you have to slide them in while pushing down on the lower intake which has a bit of movement to allow the part to go in. I took the car for a spin and acceleration seems better and smoother than before.
Thread
Thread Starter
Forum
Replies
Last Post
Shijin-Kun
Series I Tech Garage
67
Nov 14, 2023 11:36 AM