P0411 after racing beat header
Yes, I searched.
https://www.rx8club.com/tags/p0411/ Each thread ether ends with nothing or goes off on a tangent. The obx thread doesnt seem to apply. I have an 09. Had no cels before with resonated cat delete. Installed the racing beat header an immediately threw a code. I know the airpump is fine, all connections have been triple checked, and it simply worked before. I reused the OEM gasket for the air tube and installed it in the correct fashion. Any ideas? Thanks |
double check the o2 sensor and its plug, make sure all the gaskets aren't leaking and every bolt to spec.
|
I installed a few and didn’t ever hear of the problem. However, when I sold one that I decided not to use for myself, the person who bought it said he had the same thing happen. I had pm’d him several times after for follow up and he never replied back. So I’m not sure if he just blocked the code instead or got it to work. Later in the OBX thread people discuss this with the RB header. I had never saw those before today though. Some said it just went away after several drive cycles. Blocking it would be the simple solution. It’s not clear if you’re claiming to have deleted the cat without blocking those codes or not?
|
Originally Posted by sonicsdaman
(Post 4839401)
double check the o2 sensor and its plug, make sure all the gaskets aren't leaking and every bolt to spec.
Originally Posted by TeamRX8
(Post 4839403)
I installed a few and didn’t ever hear of the problem. However, when I sold one that I decided not to use for myself, the person who bought it said he had the same thing happen. I had pm’d him several times after for follow up and he never replied back. So I’m not sure if he just blocked the code instead or got it to work. Later in the OBX thread people discuss this with the RB header. I had never saw those before today though. Some said it just went away after several drive cycles. Blocking it would be the simple solution. It’s not clear if you’re claiming to have deleted the cat without blocking those codes or not?
Are there any adverse effects to blocking off the airtube? Racing beat even sells a plate for this. Thanks guys |
I have one or two laying around that I can send you.
|
Originally Posted by TeamRX8
(Post 4839414)
I have one or two laying around that I can send you.
Since I have no Cat, you think I should just delete the airpump as well? Throwing the code doesnt effect anything otherwise, correct? Thanks |
Originally Posted by TeamRX8
(Post 4839403)
I installed a few and didn’t ever hear of the problem. However, when I sold one that I decided not to use for myself, the person who bought it said he had the same thing happen. I had pm’d him several times after for follow up and he never replied back. So I’m not sure if he just blocked the code instead or got it to work. Later in the OBX thread people discuss this with the RB header. I had never saw those before today though. Some said it just went away after several drive cycles. Blocking it would be the simple solution. It’s not clear if you’re claiming to have deleted the cat without blocking those codes or not?
Observations of WB O2 sensor readings show that the air pump is pushing enough air for the WB O2 to read lean, but not enough to saturate the sensor like before when I had the stock header. Since I have no Cat, you think I should just delete the airpump as well? Throwing the code doesnt effect anything otherwise, correct? |
All times are GMT -5. The time now is 05:52 AM. |
© 2024 MH Sub I, LLC dba Internet Brands