LED turn signals type 2 switchback problem
#1
LED turn signals type 2 switchback problem
Hi Forum,
I know that LEDs and load resistors have been discussed in other threads but I have a specific issue that I want to know if anyone else has.
http://www.v-leds.com/5K-TYPE-2-DUAL-COLOR-p7114824-1-2.html
I bought these from V leds and they work great until after the headlights have been on for about 15 minutes. Then they start to hyper flash white for a second before they turn yellow for the turn signal. So the pattern is white yellow unlit instead of yellow unlit yellow unlit. I only have this problem when the headlights are on.
Any ideas?
I have done the rear signals in led too and I have the single resistor installed like v leds recommends.
Thanks.
I know that LEDs and load resistors have been discussed in other threads but I have a specific issue that I want to know if anyone else has.
http://www.v-leds.com/5K-TYPE-2-DUAL-COLOR-p7114824-1-2.html
I bought these from V leds and they work great until after the headlights have been on for about 15 minutes. Then they start to hyper flash white for a second before they turn yellow for the turn signal. So the pattern is white yellow unlit instead of yellow unlit yellow unlit. I only have this problem when the headlights are on.
Any ideas?
I have done the rear signals in led too and I have the single resistor installed like v leds recommends.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
xAgyex
Series I Trouble Shooting
19
11-13-2023 07:51 AM
CARBONRX-8
RX-8 Parts For Sale/Wanted
1
08-23-2015 09:52 PM
Touge
Canada Forum
0
08-11-2015 10:19 PM
back, indicators, led, load, mazda, problem, problems, problmes, resistor, signal, switch, switchback, switchbacks, turn, type