JamesD31

My end links are gone, so I picked up some brand from AutoZone, but was wondering if I shouldn't just shell out the money to get a better sway bar and end links? Any suggestions?

Also, here are pics of my tie rods, are they gone? Should I replace them as well?

Loki

iTrader: (1)

If you're not racing and have stock suspension, you don't need different endlinks. The adjustable ones are adjustable to adapt to changes in suspension geometry.

That tie-rod boot is cracked, so yeah I think it's time to replace it.

JamesD31

I do AutoX and probably some track days but nothing too extreme. Do you think I should replace inners and outers for the tie rods?

Loki

iTrader: (1)

Can't say based on that picture, it only shows the outer
When you say your end-links were gone, what do you mean?

JamesD31

Attached is the end links. Also, I wasn't sure where the inner is shown / outer starts for tie rods, and wasn't sure if I could see this from just the wheel well or not.

JamesD31

Anyone have any input on the tie rods? Brands to use? Where to actually check if I need inners?

I got the Progress Tech front sway bar for now.

banzairx

As far as end links get a set of Moog ones. They are much stiffer than the stock ones and way cheaper than the "racer" aftermarket ones. The rod that connects the ends on the stock unit is 5/16" diameter, The Moog parts are 1/2". They are also greasable unlike the stockers.

Part #'s for the front are K80157 & K801158. Rear is the same for both sides and is part # K750133.

You can get the set of four off amazon for $85.