Sway bar install issue...
#1
Registered
Thread Starter
Join Date: Jun 2007
Location: Santa Cruz, CA
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
Sway bar install issue...
I went to install my progress sway bars tonight but ran into a problem. All the nuts came off the bushings easily enough - as did the driver side bolt connecting the stock sway bar to the end link. The same bolt on the passenger side, however, just turned endlessly without loosening or stripping. Any ideas or suggestions?
This is my first post, btw. I've already gotten tons of great info off this site and am very grateful for all those who contribute...this really is an amazing site.
This is my first post, btw. I've already gotten tons of great info off this site and am very grateful for all those who contribute...this really is an amazing site.
#3
Registered
Join Date: Jun 2006
Location: Dublin, Ireland
Posts: 236
Likes: 0
Received 0 Likes
on
0 Posts
You should check this thread for information as to how to remove the endlinks, it should help with your issue, https://www.rx8club.com/showthread.php?t=43677.html
#4
Registered User
iTrader: (1)
Join Date: Jan 2007
Location: Mississauga, ON
Posts: 703
Likes: 0
Received 0 Likes
on
0 Posts
You're just spinning the ball joint. You'll find the threaded stud (bolt) has a hole for an alan key. Put the key in there and hold it as you turn the nut with a wrench. Easily done.
Thread
Thread Starter
Forum
Replies
Last Post
Steve Dallas
RX-8 Parts For Sale/Wanted
0
09-19-2015 09:39 AM