After reading Expo1's DIY for installing RB Sways ( https://www.rx8club.com/showthread.p...y+bar+endlinks ) I found his other post about his RB Bushings being completely dry and making a horrid noise ( https://www.rx8club.com/showthread.php?t=65304 ). Could this be caused by overtightening the clamp that holds the bushing and pushes out the grease or is it just the grease in general? Is there any other type of grease that will not dry out like the grease supplied with RB's sways? Thanks

 

normal. Drill and put in zerk fitting.

 

Im kinda young, explain to me exactly what you meant there Razz... because i have NO idea what that means...

 

Did you read ALL the posts in the thread of mine you mentioned? If you did I don't see how you could have made the above post.

 

Zerk fittings are good, along with regular inspection/lube, when dealing with low cost urethane bushings. More costly rubber bushings are of course superior as far as noise, but do wear more quickly. Copper grease is a plus.

 

I read about your fitting but im still lost as to exactly what it is, i was making sure what type of grease to get as well as what a Zerk fitting is...

 

any type of bearing grease will work

couple bux u can buy a huge bottle that will probably last the life of your car(and many car afterwards)

 

So Autozone would have it correct? and it doesnt have to be some urethane grease?

 

Autozone has them.

They have it in one section, usually next to gear oils.

Just grab a tin bottle of Mobil1 Synthetic Grease. Its Red-ish in color, its cheap, and they last very long.

 

Alright man and for these Zerg fittings what are they? Ive looked at them in Expo's pics but still kinda lost... anyone have any good pics and info on how to use them and what they look like?

 

Razz was talking about the metal clamps part.

http://wiki.answers.com/Q/What_is_a_zerk_fitting

 

So a Zerg fitting it just a cork like object that you can take out and use a grease gun or something like it to grease your bushings? then clog it back up?

 

Umm... no.
A Zerk fitting is more like a one-way valve.
You insert the grease gun nozzle onto the fitting and pump the grease.
The grease goes in but can't come back out.

 

http://en.wikipedia.org/wiki/Grease_fitting