p0335 p0335pb
 

Could this be my reason for my crank but no start problem? i can take videos and pictures if necessary.

Info: i just did a motor swap and no start problem and i got these cel codes.

Could be. Try doing the E Shaft profile reset procedure. Check out 'solution #3' here:

https://www.rx8club.com/series-i-tec...t-here-222280/

i did it. no luck. the car tries to start just doesn't turn over. although i get those codes i don't think its the reason

Is your battery healthy? A bad battery would constantly throw the eshaft profile out of whack.

Also, was your MAF replaced? Cleaned? Properly reinstalled?

figures out my crankshaft position sensor which has a different name for rx8 was positioned facing the wrong way. but by time i fixed that i blew my starter trying to deflood. yup sob story for days trust me. well hopefully i pop a new starter in and my car starts.

well at least you found the source of the issue, could have been worse! Let us know how you make out