installed lowering springs... Now i have an issue.
Before I start, I searched, tried the listed things, checked all connections are plugged in, nothing I can think of fixes my issue, Tried resetting the ECU as well, that did nothing.
I have a 2008 40th anniversary rx8. I recently installed some tanabe NF210 springs. immediately after first start up, i got an abs and tcs light on, and the cruise control doesn't work either. I checked the things i unplugged, they were all plugged in. I reset the computer using the full left - full right steering method. I still have the lights on. Anything else you need to know please let me know. I'll check in on this later. Oh, and before i forget, car drives fine, but the ABS/TCS/Cruise Control Don't work. |
Have you checked the fuses?
|
you maybe broke a wheel speed sensor
|
Originally Posted by lilring
(Post 3624508)
you maybe broke a wheel speed sensor
|
Originally Posted by EDZRIDE
(Post 3624452)
Have you checked the fuses?
|
Originally Posted by Dream20B
(Post 3624773)
I'll take a look.
|
Its actually Turn Right then Left to reset the steering sensor.
|
man i got the same proble i made a post and nobody was able to help me either?????
|
Why did you have all of that unplugged to install a set of springs??
|
when installed my coilovers i did not have any of it unplugged. my guess is dream 20b did not either? i still have not figured mine out just been driving it with lights on?
|
explain exactly how you did the turn the wheel reset. how you described it is backwards. did you have the key to ACC and not to on?
|
Originally Posted by laythor
(Post 3625416)
explain exactly how you did the turn the wheel reset. how you described it is backwards. did you have the key to ACC and not to on?
|
Originally Posted by RotaryMachineRx
(Post 3625320)
Why did you have all of that unplugged to install a set of springs??
|
Originally Posted by Dream20B
(Post 3626625)
I Didn't want to over-stretch the wires when i dropped the a arms and took out the spring assembly.
My only thoughts are: 1) Maybe you forgot to unhook a line and dropped the hub 2) Your connections/sensors got dirty and need to be cleaned 3) You are in real bad need of a wheel alignment Just throwing this out there too... any adjustments to the suspension usually mean you should go get a wheel alignment too for safe measure and even tire wear. :yesnod: |
Originally Posted by RotaryMachineRx
(Post 3626642)
Hmm, well I just installed mine last weekend and had none of these problems. Had a friend help me and held the wheel hub so it didn't fall and pull the ABS line out.
My only thoughts are: 1) Maybe you forgot to unhook a line and dropped the hub 2) Your connections/sensors got dirty and need to be cleaned 3) You are in real bad need of a wheel alignment Just throwing this out there too... any adjustments to the suspension usually mean you should go get a wheel alignment too for safe measure and even tire wear. :yesnod: I'll check on #2. #1 would be very unlikely but possible, I'll look into it too. |
All times are GMT -5. The time now is 03:28 PM. |
© 2024 MH Sub I, LLC dba Internet Brands