okay, i installed the led tail light kit from rx8 strakes. everything works/looks fine except one of the turn signals blink fast, obviously the resistor isnt doing its job and i know its clamped all the way.

so i guess my questions are, can i move it or does it cut straight through the wire, if so can i do something to retry making the resistor work

please help!

 

Chances are very low that the wire taps cut through the wire, you can take them off and try moving the resistor. If they did happen to cut the wire, just re-connect with a wire connector or solder. Double check to make sure you tapped the right wires on that side. Also make sure that when you reinstall the trunk carpeting it is not knocking the wire taps.

 

thanks for the response, im gonna tape up the resister connectors now.

i was pondering it for a while and checked my front turn signal and found out that was the reason. so its all working and good. thanks!