i just recently installed the mazdaspeed cai now i been getting a check engine light when i start up the car , dont know if it's coming on because of that though.

i hooked up my scanner to the obd and got dtc codes, U0155 and P0610, i looked in the sticky thread at all the dtc codes, but i still don't know what they mean in noobie terms, are these codes cause for any concerns, what do they mean and how do i fix them...

 

Did you reset the PCM since you installed the intake? If not pull out the bottom 15 AMP room fuse or disconnect the battery for about 1 minute. Your car probably needs to learn the new fuel to air ratios. Our 8's are smart and the computer need to adjust most likely.

 

https://www.rx8club.com/series-i-tech-garage-22/rx-8-technical-info-cel-codes-pcm-pin-list-collision-guide-26291/