RX8Club.com

Notices
Series I Tech Garage The place to discuss anything technical about the RX-8 that doesn't fit into any of the categories below.

UIM torque Specs

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 08-22-2017, 01:21 PM
  #1  
Registered
Thread Starter
 
jayh's Avatar
 
Join Date: May 2017
Posts: 48
Likes: 0
Received 2 Likes on 2 Posts
UIM torque Specs
Tried searching and i can't seem to find the Torque specs for Upper intake manifold bolts. Any help will be appreciated
jayh is offline  
Reply Like
Old 08-22-2017, 01:23 PM
  #2  
SARX Legend
iTrader: (46)
 
9krpmrx8's Avatar
 
Join Date: Jan 2007
Location: San Antonio, Texas
Posts: 33,784
Received 452 Likes on 366 Posts
Hand snug with a 10mm nut driver or 1/4" rachet. A broken UIM is a ******* PIA, you have been warned
9krpmrx8 is offline  
Reply Like
Old 08-22-2017, 01:28 PM
  #3  
Registered
Thread Starter
 
jayh's Avatar
 
Join Date: May 2017
Posts: 48
Likes: 0
Received 2 Likes on 2 Posts
I figured that. I was sweating bullet when I was removing them.
jayh is offline  
Reply Like
Old 08-22-2017, 01:44 PM
  #4  
SARX Legend
iTrader: (46)
 
9krpmrx8's Avatar
 
Join Date: Jan 2007
Location: San Antonio, Texas
Posts: 33,784
Received 452 Likes on 366 Posts
I also suggest investing in a set of thread cleaners.
9krpmrx8 is offline  
Reply Like
Old 08-22-2017, 03:33 PM
  #5  
No respecter of malarkey
iTrader: (25)
 
TeamRX8's Avatar
 
Join Date: Apr 2005
Posts: 26,720
Received 2,007 Likes on 1,636 Posts
It only happens to forum f-bombers ... you have been warned
TeamRX8 is offline  
Reply Like
The following users liked this post:
9krpmrx8 (08-22-2017)
Back to Subforum
Series I Tech Garage
View Next Unread
Suspension upgrade RX8



You have already rated this thread Rating: Thread Rating: 0 votes, average.
Show Printable Version
Email this Page

Advanced Search

All times are GMT -5. The time now is 07:48 PM.