rx8 gasket?
#1
rx8 gasket?
where can i get an intake manifold gasket?
one of those plastic ones (or plastic type material) to reduce heat?
im going to make a custom intake manifold, and need to get a flange made to start. so i need something to go off of...
one of those plastic ones (or plastic type material) to reduce heat?
im going to make a custom intake manifold, and need to get a flange made to start. so i need something to go off of...
#2
Registered
Join Date: Jul 2004
Location: Northern California
Posts: 2,196
Likes: 0
Received 0 Likes
on
0 Posts
Where will you be getting your cool intake air from...under the hood?
#4
Registered
Join Date: Jul 2004
Location: Northern California
Posts: 2,196
Likes: 0
Received 0 Likes
on
0 Posts
#5
Registered
iTrader: (3)
If you find some material let me know---i am thinking the same.
Are you going the equal runner route? going to just a 4 port? I have done some work on the oem one and since i am s/ced i am beginning to think that all the valves in this manifold is not really required any longer. I may be wrong but we will see.
I do wish the exhaust ports would match the header, i also wish we had better exhaust sleeves.
olddragger
Are you going the equal runner route? going to just a 4 port? I have done some work on the oem one and since i am s/ced i am beginning to think that all the valves in this manifold is not really required any longer. I may be wrong but we will see.
I do wish the exhaust ports would match the header, i also wish we had better exhaust sleeves.
olddragger
#8
#9
If you find some material let me know---i am thinking the same.
Are you going the equal runner route? going to just a 4 port? I have done some work on the oem one and since i am s/ced i am beginning to think that all the valves in this manifold is not really required any longer. I may be wrong but we will see.
I do wish the exhaust ports would match the header, i also wish we had better exhaust sleeves.
olddragger
Are you going the equal runner route? going to just a 4 port? I have done some work on the oem one and since i am s/ced i am beginning to think that all the valves in this manifold is not really required any longer. I may be wrong but we will see.
I do wish the exhaust ports would match the header, i also wish we had better exhaust sleeves.
olddragger
im not using the stock one at all. im using a set of gsxr ITB's. im leaving the ports stock (4 port) to see what it will make like that first.
then i will be porting it to see what advantage my port work will make...
Thread
Thread Starter
Forum
Replies
Last Post