Searched but couldn't find anything on this. How difficult a DIY is this? A guide for this would be much appreciated, thanks.

 

Unplug electrical connector...remove sensor...replace sensor...redo electrical connector......



How difficult it is depends on if you have a lift or not...will take longer on your back on the ground

 

now the question is where does the oxygen sensor plug into??
because upon looking under my 8 the other day i noticed the oxygen sensor wire harness melted to the side of my cat..and with no lift its hard to see where it goes. this may sound retarded but......plz help!

 

plugs into the cat.. once on a lift it is obvious.

beers

 

i mean the other end...the wire harness

 

once you get under the car you will find it..

beers