normal oil pressure?
#1
normal oil pressure?
Ok the manuel says that the oil pressure when the oil is at 212F should be 50.8 at 3Krpms. Since I have installed my gauges I havent had the oppitunity to get my oil temps that high(max high for me so far is 180F) but my oil pressure is around 44-46 at 3 K. Now i am picking my pressure up through a RB filter mounted sender site. Does that make up for this differance? The factory is probably registering from the electrical site below the filter. Thoughts?
olddragger
olddragger
#2
No respecter of malarkey
iTrader: (25)
oil pressure is not anywhere near as critical on a rotary as a piston engine, I wouldn't sweat that small difference. It would have been nice if they had listed a minimum allowable spec though ... kind of strange that they only list one point rather than a range or max/min
#3
Registered
iTrader: (1)
Join Date: May 2003
Location: PA
Posts: 3,754
Likes: 0
Received 0 Likes
on
0 Posts
oil pressure is going to depend heavily both on rpm and temperature
i also haven't looked at RB's adapter, but does is measure on the in or out of the filter (will make a few psi difference)
i also haven't looked at RB's adapter, but does is measure on the in or out of the filter (will make a few psi difference)
Thread
Thread Starter
Forum
Replies
Last Post
9krpmrx8
Series I Trouble Shooting
23
11-05-2015 11:45 PM