New engine time..
Wouldn't have even known I was low on compression if it didn't fail smog. To me it still runs great. Thinking about a Mazmart reman.
Is that the wise thing these days? 76k, 5w-20 Redline since new. |
First, get a Reman from Mazmart,
then Take the 5w20 away and use something with w40 at the very least be it 0/5/10w40 and premix every tank. be happy. |
Good advice. Include budget for thing like coils/wires/plugs. Engine mounts. Clutch if manual, etc.
|
Now the question is to street port or not? O_o
|
Prolly no street port! I just want to pass smog and last a bit longer.
|
Originally Posted by RX3+5
(Post 4446492)
Wouldn't have even known I was low on compression if it didn't fail smog. To me it still runs great. Thinking about a Mazmart reman.
Is that the wise thing these days? 76k, 5w-20 Redline since new. |
Stealer. To lazy to pull the Shrader out of my compression tester!
|
Thinking about a local rebuilder.. 600.00 shipping each way kills.
|
you sure its not a bad cat? there is only one real emissions part on the car, and its the kitty cat...
or if you like, mine passed smog with a dead/dying chamber on one rotor |
Yup. New cat tried.
|
u in CA? should be a lot of builders around ur area
|
Shipping is only 300.00 each way.. Better.
|
Originally Posted by RX3+5
(Post 4446887)
Yup. New cat tried.
|
Front 4.4@245 and rear 5.4@245.
|
Compression Tested today
I had a compression test done at the stealership today. I couldn't stand not knowing whether or not it was going on me or not so I dropped the $99.95 @ Cavalier Mazda in Chesapeake, VA......kinda cheap compared to some others reports I've read on here. :p:
It shows engine is in good condition. The numbers are as follows: R1=7.9,7.9,7.7 & R2=7.8,7.8,7.7 Report doesn't mention at what RPM. Should I be concerned with that? Apparently standard is 8.5 & minimum is 6.9 so basically my engine is right b/t the two. Anyone have any input on this and whether or not these numbers seem feasible and actually "good"? :dunno: Feedback is more than welcome as long as they're educated and not an "opinion". Factual information only is requested. Thanks in advance. Anthony |
New engine from Mazmart being installed in the next few days. New poly mounts and a clutch kit at the same time.
Switching to RL 10w-30 and RL 2C premix after I smog. Thanks everyone! |
Putting a new engine in mine as we speak....
|
New engine in. Much more low end now! The front pulley has a bit of a wobble though. We called Mazmart to let them know. For now, we will run it. I hope it doesn't eat belts...
|
Uh, you will wanna get that wobble fixed ASAP.
|
That means sending the engine back...
|
Well at least do not run it until you work something out with Paul and figure out what the exact problem is. It could be rather serious, stack problems are fairly common, it happens.
|
Slight tangent - Is it possible to lift the engine out of the bay with the crank pulley attached? (specifically an Agency Power pulley)
|
The actual pulley part is likely not the problem and is easily removed.
|
Not the pulley. I just looked at it.. Disturbing.
|
Probably a bad stack......
|
All times are GMT -5. The time now is 04:34 PM. |
© 2024 MH Sub I, LLC dba Internet Brands