ok, i wanted the short shifter look so me and my buddy took off the **** and used a dremel to cut the metal shifter, i cut about 2.5 inches and now the **** hits the bottom peice!!! and wont go into the gears! does anyone have this part laying around that would be willing to sell it to me?!!!!!

I need help ASAP, thanks! I basically have no **** and have a wrench gripped on tight so I can aleast move the shifter.

HEEEEEEEEEEEEEELP!

 

good job



anyways, you would have better luck in the FS/WTB section

 

you did what?! Oh boy...

You're gonna need to buy an all new shifter. I would look in the FS section or ask Paul over at Mazmart. GL.

 

You should seriously make a new post here: (Mazmart)
https://www.rx8club.com/mazmart-88/

 

I always thought the stock already 'looked' short. It just throws long.

Get the RP.

 

You've got to remember that this is the same guy looking for... "naws stickers" and "pictures of a faux intercooler installed" hahaha

 

I'll sell you my old shifter for $100 shipped.

 

maybe a different shift **** will work.

 

"i basically have no ****"

funny stuff... good luck, though.

 

well that was a stupid thing to do... now get a new shifter and dont do anything stupid with it.

 

thats funny. measure twice, cut once.

last time i did anything like that was on my old 92 civic hatch. i had a short throw shifter in there, and then cut something like 2.5 inches off. you wanna talk about short throw.....

 

ill sell you mine $200 shipped or if your close ill install it

 

 

Try this take the piece that was cut off the shifter and screw it back into the **** so that the **** no longer sits low enough to hit the console. Don't forget to use Red Lock Tight on the threads to make sure the piece doesn't work itself loose!!

 

oh boy... its all about the looks isn't it... fake intercooler, NOOOSSS decal, and cutted shifter.

 

Oh please get the RP Short shifter since you've already destroyed your old one

 

isnt 2.5 inches the whole thread of the shifter?

 

dude if you guys haven't noticed already this guy is a friggin troll... Search his last few posts, its either he's a really really stupid ricer (which i think he's being too obvious about) or he's here trolling, I think it's the latter.

 

i just got out my stock shifter... yes it is past the whole thread. its at the middle thickness where the shifter thickens to secure itself in the shift boot... all i can say is... lol

 

i will continue to believe he is a ricer. it's just funny that way.

 

man i knew it passed the shifter just by estimating with my thumb and my index finder! LOL thanks for confirming my guess! hahaha

 

are you sure.... i think if he cut off the end of the vice grip that tightens it.... that knerred ****.... he could thread it and put a **** on it....

btw... i have a stock shifter sitting in a box above my spare motor..... and it will continue to sit in that place....

beers

 

I'd prefer to believe he's a troll. The thought some one this "bright" is actually licensed to, much less capable of driving is,.... well frightening.

What's his home brew solution for putting in a quick ratio steering assembly?

Ricer or troll, maybe the only way to know for sure is if he'll post some pictures of his car

 

"A Troll he must be, yet much Ricer I sense in him...." - Says Master Yoda

 

exactly what is a troll?