This may be too much to ask but here I go..

I'm wiring up a TCS for my rx8 that didn't have TCS.

I need the combined sensor information.

It's located over the transmission tunnel in the rear of the car (driveshaft tunnel). would be nice if you already have the interior apart.

I need to know what voltage "F" position reads when the car is on.

I would also like to confirm that "B" is 12v when ignition is on, and "A" is contiguous with chassis ground.

I think "E" and "C" are the signals. No idea what "D" is.. I think it has to do with CAN bus or diagnostic testing.

Thanks in advance.

 

got the info. Bosch was surprisingly helpful.

Reference voltage is generated by the sensor and that just needs to be connected to the ABS/DSC box or in my case, left disconnected since I'm using haltech.

Others I have listed are correct.