Replaced my OEM coils Sunday with the BHR coils. Spark plugs were fairly new so did not swap them.

Question: After spending 4 hours doing it wrong the first time and then finally getting it back together I could not snake my plug wires the original way so two are over the top of the wiring harness instead of below and through the separator. They are not touching much of anything but wonder if anyone else had trouble running the plug wires and if they had any issues.

Runs great, strong, no hesitation in the upper range. Had 34K on the OEM coils and think I was getting an issue when the outside temp went over 90F. Cutting out sometimes.

 

I couldn't use the OEM loom, not enough slack .