AT Shifter Cover
#1
I4NI
Thread Starter
AT Shifter Cover
How do ou remove the shifter plt below the shifter ****? Does it snap off? Pop off? Screw off? I know some of you installed shifter booths but failed to mention(Or I skiped over that part) how the plt was removed.
Thanks!
Thanks!
#2
Destroying Threads
it pops of, but its one piece with the center console, you have to pop the bitch off, there is 1 wire under there that lights up the modes you have to disconnect it
its really easy, if you have problems, feel free to contact me, atilla, phil, mdw100, and all other people who owns an AT rx8, in other words, spam
its really easy, if you have problems, feel free to contact me, atilla, phil, mdw100, and all other people who owns an AT rx8, in other words, spam
#4
Destroying Threads
you pop the back out, I had to take out the entire console to install my interior lights, and yep, you will see the tranny under there, why are you doing this though?
#8
Destroying Threads
^ opposite of me, I have had all mts in the past, and this is (wierd huh) my first AT, and I am falling asleep on the road, which is one of the reasons why I am driving at 100mph+
everyone on this forum no longer cares because they think I'm gonna be dead soon anyways so w/e
besides dude, its not worth the hassle just leave it alone for now
also, did u know u can change the light bulb under there?
everyone on this forum no longer cares because they think I'm gonna be dead soon anyways so w/e
besides dude, its not worth the hassle just leave it alone for now
also, did u know u can change the light bulb under there?
#9
I am THAT guy
iTrader: (1)
haha!
i knew my name was gonna be dropped somewhere in here...haha
it's easy to pop the thing open - there's a DIY for it but the easy way is just to slide your center console (to your cup holders) there should be this little piece you can slide out - from there take a flat head in there and just 'pop' it open...from there the other points are easy to open...it's fairly easy from there...get a leather sock n' cut holes were needed and you're pretty much done...careful not to drop anything in that slot tho when you open it...you'll probably never see it again...like my house key
i knew my name was gonna be dropped somewhere in here...haha
it's easy to pop the thing open - there's a DIY for it but the easy way is just to slide your center console (to your cup holders) there should be this little piece you can slide out - from there take a flat head in there and just 'pop' it open...from there the other points are easy to open...it's fairly easy from there...get a leather sock n' cut holes were needed and you're pretty much done...careful not to drop anything in that slot tho when you open it...you'll probably never see it again...like my house key
Thread
Thread Starter
Forum
Replies
Last Post
Jst4fun
RX-8 Parts For Sale/Wanted
18
04-17-2021 07:43 AM
SimonT182
RX-8 Parts For Sale/Wanted
4
10-02-2015 10:33 AM
Evan Gray
Series I Trouble Shooting
0
09-26-2015 12:30 PM