Removal of Volume Knob
#1
Registered User
Thread Starter
Join Date: Mar 2006
Location: Wetumpka, AL
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Removal of Volume ****
Hey folks. Just a quick question that I need an answer for. I just ordered a custom **** for my stereo ( like the one found here --> http://cgi.ebay.com/ebaymotors/RX8-R...spagenameZWDVW ) and wanted to know if there was anything special I needed to do to take off the factory volume ****. I tried the old tried and true method, just try yanking it off, but it didn't budge. Should I use a small flat-head screw driver to force it off??
Thanks ahead of time for any info!
Hudson
Thanks ahead of time for any info!
Hudson
#2
Metatron
iTrader: (1)
Pull.....
Pull, and pull some more.
A screwdriver will just chew it, and it's surround, up.
You could try a set of vice-grips with cloth around them, but there is no trick, just pull.
S
A screwdriver will just chew it, and it's surround, up.
You could try a set of vice-grips with cloth around them, but there is no trick, just pull.
S
#5
I just changed mine yesterday. Pull HARD. I thought i was going to break it, but it popped off eventually.
You'll need to pry the little retainer out of the old **** and put i tinto the new one. Pulling it out isn't a problem, but you need to press it into the aluminum **** with a lot of force (hint: I used a penny so it wouldn't dig into my thumb)
You'll need to pry the little retainer out of the old **** and put i tinto the new one. Pulling it out isn't a problem, but you need to press it into the aluminum **** with a lot of force (hint: I used a penny so it wouldn't dig into my thumb)
Thread
Thread Starter
Forum
Replies
Last Post
Racingjunkie
Series I Wheels, Tires, Brakes & Suspension
2
09-29-2015 05:05 PM
Learners_Permit
Series I Interior, Audio, and Electronics
8
09-27-2015 07:38 PM