Notices

Rear speaker removal?

Old May 22, 2005 | 09:15 PM
  #1  
chinkysuavo's Avatar
Thread Starter
Registered User
 
Joined: May 2005
Posts: 8
Likes: 0
From: San Diego
Rear speaker removal?

Does anyone know how to get the rear speakers off? I looked around a bit but didnt see any obvious screws or clips. I know it might involve removing the rear seats but I dont even know how to get started on those, Help! (did search...no result)
Reply
Old May 22, 2005 | 09:43 PM
  #2  
StealthTL's Avatar
Metatron
iTrader: (1)
 
Joined: Mar 2003
Posts: 7,286
Likes: 184
From: A Pacific Island.
Start.....

I can get you started in the seat department, after that let us know how you do it!

The bottom seat cushion just has two metal clips at the front - grab and lift straight up, and out.
The seatback has two (14mm) bolts at the bottom, and two clips at the top - undo bolts, then lift straight up, undo seatbelt from seat, and out.

Post a little 'how to' when you get the speakers out!

S
Reply
Old May 24, 2005 | 03:37 PM
  #3  
wedge357's Avatar
ShinkaMan #748 SV6P
 
Joined: May 2005
Posts: 536
Likes: 0
From: Lake Worth, FL
To get to the rear speakers you have to remove the 2 outer side deck pieces (the middle stays). To remove the rear decks, you need to first remove 2 plastic pop-out pins along the front where the seatback hides it, one is close to the seatbelt and the other one is along the middle. Next, apply constant lifting pressure starting from the front inner corner to pop the deck piece off the holding clips, there are 2 big metal clips you need to pop through but as long as you do it slowly you should not break anything (i have taken mine out twice without problem). After this just lift the plastic piece away from the rear window to expose the speaker. the speakers are easily removed from the metal car frame.
Reverse the procedure for reassembly but don't forget to twist and pull out the metal clips from the car frame and reattach them to the deck piece you remove for ease of reassembly. Just pop them back in with firm pressure especially where the metal clips are. reattach the 2 plastic pins you remove earlier then reassemble the seats. TADA!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
RevMeHarder
New Member Forum
8
Jun 1, 2026 02:30 PM
Carbon8
RX-8's For Sale/Wanted
42
Feb 27, 2020 08:39 AM
Paul_Y
New Member Forum
21
Sep 21, 2015 02:23 PM
yapakanichi
Series I Exterior Appearance and Body Kits
5
Sep 17, 2015 04:23 AM
mattymack
New Member Forum
2
Sep 6, 2015 10:33 PM


Thread Tools
Rate This Thread
Rate This Thread:
You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 03:33 PM.